Recommended Posts

Posted

We just replaced the glass in one of these fixed, gable windows.   This is the house I built in 1989, so the windows are 29 years old.  They are custom made by Anderson.

We replaced one a year before the 25 year warranty ran out that had lost the seal, a few years back, and it wasn't much trouble.   The extra years have taken a toll on the plastic.   On the one we replaced this week (the one over the right end awning window in this picture-4 feet wide), and it's now noticeably more brittle than just a few years ago.  I ended up getting a flexible Hyde putty knife, and sharpening one side of the end of the blade.  It took at least an hour to persuade the sharp, thin blade behind the vinyl, all around, to cut the sealant between the cladding, and the glass without breaking the brittle vinyl.  There is a porch roof out there, so it wasn't like I was standing on a ladder for an hour-just tedious.

I think if one of the others needs replacing in a few more years, we will probably have to replace the whole unit.

We had to set scaffolding up in the house, as the top of the row of awning windows is about 13 feet above the floor.    I had to cut the seal on the outside, but the glass was taken out on the inside by removing the stops.

Everyone used to like vinyl cladding, but with lifetime warranty paint these days, I'll not use clad windows again.   I've seen Cypress that has lasted over two hundred years, but I doubt any plastic will last that long.

In the future, I'll be going will Cypress molding on the outside, painted with the best paint available.

 

IMG_0717 (1280x960).jpg

Posted

I have seen so many cladding failures in less than a decade. I now only recommend  aluminum clad, solid vinyl, or wood. Timely topic too as tax returns often target failing windows and such. 

Posted
3 hours ago, RichardA said:

Vinyl will to last 200 years, in the landfill.

Only because modern landfills are sealed better than Granny's jelly jars. A little active composting would go a long way toward returning most artificial materials to their natural state.

Posted

If I ever use such fixed glass units again, I'll make the frames myself.  The molding on the outside will be plain shaped Cypress, held on with stainless screws, so the exterior molding can be taken off to get the sealant out.

It's also so much easier putting up just the glass alone, from the inside, than getting a whole assembled unit in place, high on the outside. so future frames will be installed first.

Pictures coming on a custom skylight install that will apply to this type of application too.

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Who's Online   0 Members, 0 Anonymous, 32 Guests (See full list)

    • There are no registered users currently online
  • Forum Statistics

    32k
    Total Topics
    437.5k
    Total Posts
  • Member Statistics

    26,007
    Total Members
    3,644
    Most Online
    FurniCore
    Newest Member
    FurniCore
    Joined