Popular Post gee-dub Posted July 20, 2022 Popular Post Report Share Posted July 20, 2022 I hope I haven't already done this . I use a shop made flexible sanding block for things like the Scott Lewis cutting board. If you've ever done box joints you already know how to do this. Special jigs are nice but lets pretend all we have is a miter gauge and a sacrificial fence. I use 3/4" MDF so that's what I will demonstrate here. Set your FTG or TCG blade at about 1/8" from the stock's thickness height. Use a blank that is about a foot longer than the block you will cut off of it. Attach a sacrificial fence to your miter gauge and make a cut through your blank and the fence. Please ignore the second narrow cut in the sac fence. That is left over from something else. My block is short because I have a method of dealing with that. Let's just pretend my blank is about a foot longer. The cut that you just made through the block and the sac fence gets a key installed on the sac fence. I use a little Rapid Fuse and a piece of 1/8" hardboard. This doesn't have to be perfect. Space you fence so that the key is to the right of the blade the same dimension as the kerf width. This is 1/8" in my case. Set the cut you made in your blank over the key. You can see where this is going . . . Make a through cut, hop the blank over so that the cut you just made sets on the key. Cut again, hop, cut, hop, cut . . . Do this for the length that you want your block. For 3/4" MDF a block about a foot long has some reasonable flex. Some folks use "bendy ply" and that is fine. I didn't have any handy and so went with MDF. The bendy ply will make a tighter curve. The MDF will do about a 12" radius max. This works fine for the cutting boards of the type discussed. 4 Quote Link to comment Share on other sites More sharing options...
Coop Posted July 20, 2022 Report Share Posted July 20, 2022 Glenn, as brittle as the remaining MDF ribs are, why not use ply or even hardwood? Is it due to the flexibility of the remaining 1/8” flat surface that it gives over the other two? Quote Link to comment Share on other sites More sharing options...
gee-dub Posted July 20, 2022 Author Report Share Posted July 20, 2022 Yes, it’s a trade off. Quote Link to comment Share on other sites More sharing options...
Mark J Posted July 20, 2022 Report Share Posted July 20, 2022 Any reason to prefer 3/4" material? Seems like you could produce similar results in a 1/2" board. Quote Link to comment Share on other sites More sharing options...
BillyJack Posted July 20, 2022 Report Share Posted July 20, 2022 If you don't want to make and have some wiggle board, it could be used. Was this created to sand it smooth after a route, after a rough cut or just to smooth for finishing? Quote Link to comment Share on other sites More sharing options...
gee-dub Posted July 20, 2022 Author Report Share Posted July 20, 2022 On 7/20/2022 at 7:13 AM, BillyJack said: If you don't want to make and have some wiggle board, it could be used. Was this created to sand it smooth after a route, after a rough cut or just to smooth for finishing? I use this version primarily for edge sanding 1/4" or 1/2" MDF templates after rough cutting at the bandsaw. Long, gentle curves and usually not too aggressive. Quote Link to comment Share on other sites More sharing options...
BillyJack Posted July 20, 2022 Report Share Posted July 20, 2022 I understand... Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.