Recommended Posts

Posted

I am currently updating my shop (who isn't?!), and covered my machines with dropcloths while painting. I had to mud, prime, and paint both the walls and ceiling, so it took a few days. Anyways, I finally finished and put my machines back.

I removed the dropcloths, and found a small amount of rust (about the size of a quarter) on my jointer fence, and another on my table saw top. I immediately scrubbed with WD40 and 0000 steel wool to remove the rust. Then for good measure, I cleand the entire machine top of both the jointer and tablesaw, sealed with TopCote, and then waxed with paste wax.

The areas where there was rust is now slightly dicoloured (blackish). Can this black be removed?

I thought maybe of polishing the surface with Autosol, or another metal polish. My TS top has some other stains that I thought the metal polish could help with too.

Is metal polish a bad idea?

Posted

I suspect you'll need to sand past the coloration marks. You'll want to be careful not to do just the spot either, or you could end up with a slight divot. Someone else might have a better idea...

Posted

you will spend thousands of hours sanding to get the top perfectly level again if you try and sand past the discolored spot. i have a few kids in my classes who are compolsive about cleaning and i try to get them to realize that a shop is messy and if its perfectly clean that just means you dont use the space.

  • Like 1
Posted

Getting that first spot of rust a on a cast iron surface is like getting the first small dent in your new car. It's gonna happen. You know it's gonna happen. No one knows when it is gonna happen. Yet, when it does happen, you're still upset by it.

Personally, as long as the rust itself is removed, the top is flat and smooth, I would put your surface protector of choice on it, and not worry about it.

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Who's Online   1 Member, 0 Anonymous, 41 Guests (See full list)

  • Forum Statistics

    32.1k
    Total Topics
    437.6k
    Total Posts
  • Member Statistics

    26,009
    Total Members
    3,644
    Most Online
    Joseph b
    Newest Member
    Joseph b
    Joined