Recommended Posts

Posted

I just got in a new power tool in my shop and I though I would share a couple pictures of the move in process and a couple of my test pieces. Also if you guys have ideas of what I should try to design and cut out I am all ears.

post-14177-0-75147300-1376354103_thumb.j

post-14177-0-59186500-1376354107_thumb.j

post-14177-0-80424100-1376354110_thumb.j

post-14177-0-33851800-1376354119_thumb.j

post-14177-0-98275100-1376354317_thumb.j

post-14177-0-28539400-1376354320_thumb.j

Posted

Nick I have some spare walnut, so I will carve the stallion tonight. 

 

Mds2 The spindle is ridiculously cool and super quiet now I just need to figure out how to put a muzzle on my dust collector and air compressor that need to be on at all times.

Posted

3 guys on the back of the bobcat to counterbalance?  obviously not a handheld...

 

 

Nice addition!  how long did it take to create the first spindle?

Posted

Now I see why router is in quotes! That is an impressive machine!

 

Yeah I can't really put it in the same category as a 3HP Porter Cable.

 

 

3 guys on the back of the bobcat to counterbalance?  obviously not a handheld...

 

 

Nice addition!  how long did it take to create the first spindle?

Without 3 guys on the back it was a little like a teeter totter. The thing I loved was the truck driver was the first to volunteer to sit on the back. It took some where in the 15-30min range to turn the first spindle. The break down of time is something like 20 min to turn the 4x4 down to a 3in round, then maybe 5 min to do the spirals with two different bits. I really what to figure out a quicker rounding process but even if I don't 30min is not a bad amount of time to process a part like that.

Posted

 I really what to figure out a quicker rounding process but even if I don't 30min is not a bad amount of time to process a part like that.

 

My buddy runs a big DMS they still run the square stock through the moulder before machining. The DMS is on a much larger scale but it takes less than a minute to machine a similar column much larger. If your going to be doing lots of these its something to think about.

Posted

I don't have or have room for a molder but that gives me the idea I can get a big 1.5inch round over and program the CNC to route using the round over profile then switch to the Surfacing bit to bring it down to actual size. Then CNC Spindle should be able to hog through the material quicker and more efficiently than the size molder or router that I would get right now.

Posted

Tom that Apprentice Pillar is crazy. And I am so happy I can say I could make it if I had a 3d model of it. The crazy thing with cnc is the question no longer "Can I make it?" it turn into "how quickly/efficiently can I make it?"

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.