baok Posted November 10, 2013 Report Posted November 10, 2013 I'm getting pretty frustrated with rabbets. And by this I mean I'm frustrated with using my #78 rabbeting plane on the cross-grain rabbets. My plane is a knock-off brand reproduction of a Stanley #78 which has a little nicker on one side. It was unsharpened when I got it and I put an edge on it but it has never really worked well. I've watched videos of The Schwarz making rabbets with his and he seems to do it perfectly. I am prepared to accept that his level of experience makes a big difference but still. My rabbets look like crap. I think the nicker is too long and throws off the operation of the cutter. But my question is: How would you go about tuning up a rabbeting plane? How much is the nicker supposed to protrude? Any and all advice is appreciated. Quote
Llama Posted November 10, 2013 Report Posted November 10, 2013 Are you dragging the plane backwards first to allow the nicker to sever the fibers first? Quote
Tom King Posted November 10, 2013 Report Posted November 10, 2013 As with any plane, super sharp solves all sorts of problems. It needs to be a couple of steps sharper than being able to shave hair, and not take too big of a bite. Most of the skill in using a plane is being able to sharpen, and set it correctly. Hands make a difference too, but even the best hands can't do good work with an improperly setup tool. The nicker needs to be just ever so barely below the cutting edge of the iron, and it needs to be sharp too. I have the Record equivalent of that plane and use it all the time. Quote
baok Posted November 10, 2013 Author Report Posted November 10, 2013 Aha! The nicker is sticking out really far - like 1/16". I will shorten that and see how it goes. Quote
baok Posted November 10, 2013 Author Report Posted November 10, 2013 Success! I ground the nicker way down and resharpened it and Things work much better now. This plane was pretty much a piece of junk; I had trouble with the shavings piling up against the cap iron so I took it apart and ground away on that until it mated flat against the iron as well as coming to a sharp edge so as to direct the chips up and out. Mostly just up actually. But now after adding some wax to all the pieces that slide on wood, it works a great deal better now. I have to completely remove the cap screw since I can't take the cap iron (not sure that's the correct term BTW) and iron out. The cap has an oblong screw hole suggesting that you should be able to get it out without completely removing the screw and I haven't fixed that part yet But it's actually usable now. And with all that working as it should, my rabbets are square and don't stair step away from the vertical wall now. As much. On to the next problem. 1 Quote
TerryMcK Posted November 11, 2013 Report Posted November 11, 2013 Some nickers are a pile of junk anyway. I never use them just scribing a knifeline across crosscuts. Glad you got it sorted out Greg. Quote
nateswoodworks Posted November 11, 2013 Report Posted November 11, 2013 I have the Stanley and the biggest help I had was Schwarz talking about not grasping the tote, just cradling it and pushing forward with it and using your other hand to apply the downward pressure. Now with a very sharp iron I have great success with mine. I will try to find the article that he talked about this in later if you would like. Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.