JustinScottDeVico Posted November 13, 2013 Report Posted November 13, 2013 Hey all, So I made a mistake and was wondering if anyone has any parts for an adjustable block plane for sale. I was trying to take the screw that the adjustable nut screws off for restoration purposes but ended up collapsing the threats and not screwed up the brass nut as well in the process. Anyone have any parts the are willing to sell floating around. Any sources would be greatly appreciated. Thanks justin Quote
Tpt life Posted November 13, 2013 Report Posted November 13, 2013 Different planes can have different thread pitch and counts per inch. Can you specify what plane you are working on? Quote
Tom King Posted November 14, 2013 Report Posted November 14, 2013 Maybe NHplaneparts on ebay. I've gotten a fair amount of stuff from them. 1 Quote
JustinScottDeVico Posted November 14, 2013 Author Report Posted November 14, 2013 C Shaffer - it looks to me like a Stanley 9 1/2 I'll check that eBay user Quote
JustinScottDeVico Posted November 14, 2013 Author Report Posted November 14, 2013 Tom thank you...found exactly what I needed. Now onto removing the thread. How do I do this? Especially without screwing up any more threads. Quote
TRBaker Posted November 15, 2013 Report Posted November 15, 2013 Justin, a picture would be good at this point. Welcome to the forum, btw. Quote
Tom King Posted November 15, 2013 Report Posted November 15, 2013 I would think that threaded rod is held in the base by some sort of adhesive like Locktite. It will probably take heat to break it down, but you don't want to damage the Japaning. I'd use a little Butane flame torch that I use for pulling golf club heads off of graphite shafts to heat the stud. Since the stud needs to be changed anyway, I'd use ViseGrips to clamp onto it to back it out, but don't clamp it on until the stud is good and hot. Use red Locktite on the new one. This is just guessing though. I couldn't find anything specific online. The nhplaneparts guy will probably know. Quote
JustinScottDeVico Posted November 15, 2013 Author Report Posted November 15, 2013 C Shaffer that's the exact one. Thank you. I spoke to the nhplaneparts people and they suggestes thick leather and pliers. So a little heating might do the trick? My wife has a sweet little hydroflux torch that concentrates the flame real well I may give that a shot. Thank you all I really appreciate it. I'm gonna turn my extra plane body into an infill block plane Quote
Tpt life Posted November 15, 2013 Report Posted November 15, 2013 I also keep rubber roofing scraps for such things. Just don't mix heat and rubber. Double nutting is my preferred removal for arrangements with standard threads. I am not sure if you'll find reverse thread nuts at your hardware though. Quote
JustinScottDeVico Posted November 15, 2013 Author Report Posted November 15, 2013 Double nutting? Sounds dirty Quote
Tpt life Posted November 15, 2013 Report Posted November 15, 2013 Take two nuts and loosely run them down near the plane casting. Turn the nuts in opposite direction until they bind against each other. They will purchase the threads and potentially allow you to break the thread locked into the casting. Two good visuals. Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.