Recommended Posts

Posted

They showed up in the mail today. Time to tune 'em up and take 'em for a spin.

 

They have original SW blades, with plenty of metal left. Should I regrind and hone them or buy new steel?

Any advise on flattening the bottoms? Should I worry about keeping them square to the sides?

post-15223-0-49408300-1394157458_thumb.j

post-15223-0-61359400-1394157460_thumb.j

Posted

The irons in them will cut fine. There is not a lot of body to warp so I would be surprised if they need to have the sole flattened unless they have been abused. Wet dry sand paper on a flat surface is cheap and easy if flattening is necessary. You likely won't ever need the sides of these planes as a reference surface so I personally wouldn't bother with squaring the sole to the sides or vice versa.

Posted

I'm still using the stock irons in 3 of mine, and a Hock in the fourth one.  I keep one of them in my tool belt depending on what I'm working on.  The stock irons do just fine, but the square corners on the Hock are a pain in a block plane. 

 

Every sole did need flattening though.  It doesn't take long to flatten one of these little planes.  Start with 400 to see what it needs, and go up in coarseness if you need to.

Posted

I have an older Stanley 60 1/2 like you have to the right and a knuckle cap plane like the other two you have pictured , mine is a Sargent but pretty much the same, and I love them both. I have the new redone Stanley 60 1/2 that I got a great deal on but I would take either of the old ones over it any day. For block planes, unless they have lost their temper due to careless grinding, the original irons are perfectly fine, bench planes I prefer to upgrade. I wouldn't get to concerned about their flatness, as long as they look flat ans are good around the mouth they are good to go; it's not like your surfacing with it. Both of mine were out a tad and I had flattened one and not the other, I can't tell a difference. Enjoy!!

God bless

Nate

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.