Vyrolan Posted November 28, 2014 Report Posted November 28, 2014 Because if it's too far the piece tips before reaching it...sigh. (The piece is cut because I cut the edge off and am still using it. It's just an interior panel of a shop cabinet so that damage will be forever hidden by a drawer.) Quote
..Kev Posted November 28, 2014 Report Posted November 28, 2014 Great reminder, thanks for sharing! Quote
Vyrolan Posted November 28, 2014 Author Report Posted November 28, 2014 ouch! That's what my poor Grrripper was saying. As it rotated over the top of the blade the corner/edge took out one of the plastic knobs. I'll have to figure out someway to get it out to replace. Kudos for the Grrripper by the way. Quote
wdwerker Posted November 28, 2014 Report Posted November 28, 2014 One great thing about Grrrippers Is they sell parts. I've already nicked the legs in a few places on mine but it hasn't affected the use yet. I clean the pads with those alcohol wipes for my glasses. Keep your outfeed close... I keep mine very close, with a small beveled edge and it's about 1/16 lower. Quote
TerryMcK Posted November 28, 2014 Report Posted November 28, 2014 Could have been your fingers. Thankfully it worked and as Steve says you can get the spares from them. Quote
Cochese Posted November 28, 2014 Report Posted November 28, 2014 Been there, done that. On both problems. I've dropped my Grriper too many times, I'll need to figure out how much the parts will be. Quote
Vyrolan Posted November 28, 2014 Author Report Posted November 28, 2014 Yea for now I just took a knob from one of the other accessories I never use, but I saw that you can get all the parts cheap and easy online. They don't try to gouge you on the shipping or anything. Quote
bushwacked Posted November 29, 2014 Report Posted November 29, 2014 How far was the outfeed away? Quote
Vyrolan Posted November 29, 2014 Author Report Posted November 29, 2014 How far was the outfeed away? I was using a little Ridgid flip top table and it had kinda drifted away as I moved it around for different cuts. Flip top was probably 9-12 inches from the back of the saw and the piece I was cutting was 19" in depth. Quote
dwacker Posted November 29, 2014 Report Posted November 29, 2014 Think before turning on the power. This applies to all machines. 1 Quote
wdwerker Posted November 29, 2014 Report Posted November 29, 2014 I never try to save the part when something goes wrong! Let it go and get out of the way ! But even better plan the cut, check the needed clearance on INFEED and OUTFEED . Both of my tablesaws have a full sized outfeed table that doubles as an assembly table. I do a lot of work with sheet goods and tend to rip first, stack the strips out of the outfeed path, then crosscut from the stack. Constantly checking width , length and squareness. Quote
Vyrolan Posted November 29, 2014 Author Report Posted November 29, 2014 I never try to save the part when something goes wrong! Let it go and get out of the way! Oh I didn't try to save it in the moment. My twitch reflexes from video games kicked in and I nailed the power switch on the saw and just backed away moving hands outward and upward. It was only afterwards that I assessed the part that got mangled (the cutoff left of the blade) and decided to keep it and use it as planned. Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.