Brendon_t Posted January 14, 2015 Report Posted January 14, 2015 Hey all, like many here, my work space is shared by a family in a garage. I have a 72"x96" rack that most of my power toys sit on with my ts and drum sander on rolling stands in the corner. I normally use a HF roller stand as my outfeed support but would really like something to actually catch the material as it exits the cut area. I'm considering making a removable outfeed support that latch to the back side of the fence and free standing folding legs. Anybody seeing any fundamental issues with the idea before I get to deep into it? Quote
wdwerker Posted January 14, 2015 Report Posted January 14, 2015 Adjustable feet on the legs will be smart. Quote
Brendon_t Posted January 14, 2015 Author Report Posted January 14, 2015 FGE... I just switched my wording sound in the search engine and found exactly what I'm talking about. . Guess I'm just boosting post count now Quote
RichardA Posted January 14, 2015 Report Posted January 14, 2015 FGE... I just switched my wording sound in the search engine and found exactly what I'm talking about. . Guess I'm just boosting post count now Boosting post count and learning.....Not a bad combination! Quote
ColinF Posted January 14, 2015 Report Posted January 14, 2015 Hey all, like many here, my work space is shared by a family in a garage. You'd have a lot more room if you let your family in the house, trust me, I used to keep mine locked up in the garage too, it's just too much of a hassle to tie them up in the backyard when you want to make something! 2 Quote
ResidentEvil Posted January 15, 2015 Report Posted January 15, 2015 I built one that hangs on the back of my unisaw. Couple things to consider: Depending on your saw, you may have to make a short length that attaches to the back and doesn't fold down. To be able to clear your fence rails and such. If you do make this short non folding section. Make braces tovhold it level. I'll try to remember to grab a pic of mine to show you tomorrow. I built folding legs that attach up under the bottom of the table with magnets. Its handy nor to have to worry about latches. Levelers on the bottom of the legs, as previously mentioned, are really handy. Not sure about making it removable. Mine is attached all the time, but when folded it doesn't take much space and the way I built it it still allows me to wheel the saw around easily. Quote
Raefco Posted January 15, 2015 Report Posted January 15, 2015 You'd have a lot more room if you let your family in the house, trust me, I used to keep mine locked up in the garage too, it's just too much of a hassle to tie them up in the backyard when you want to make something! I quit tying mine up when I put them out, they just keep coming back, maybe if I stop paying for cell phones and car insurance (sigh) Quote
Craig Posted January 15, 2015 Report Posted January 15, 2015 I have a 12" deep out feed on my TS the width of my top and use the Ridgig out feed supports when needed. The short out feed meets my needs about 90% of the time. Quote
ColinF Posted January 15, 2015 Report Posted January 15, 2015 I quit tying mine up when I put them out, they just keep coming back, maybe if I stop paying for cell phones and car insurance (sigh) lol!!! I know mine wouldn't come back with out the cell phones! Quote
Tom King Posted January 17, 2015 Report Posted January 17, 2015 The one on our portable saw sits on, and clamps to the rear Bies angle with a couple of DeStaco clamps. Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.