Recommended Posts

Posted

Will planing boards that have dried glue squeeze out on them gum up the planer knives?  I make cutting boards for family members for Christmas presents and have been using my drum sander to flatten out the cutting boards after they are glued up.  I was wondering if I could use the planer the get them flattened out then just finish sand them with my orbital sander. 

Thanks,

Josh

Posted (edited)

Not gum up but I've heard that a glue line can nick you knives. I have not noticed that and I send glued up panels through my planer all the time.

I think of more concern is that if you're making end grain cutting boards, sending them through the planer can cause the board to break to pieces (a very dangerous situation).

Edit: Using the drum sander as you have been is the usual method.

Edited by davewyo
  • Like 2
Posted

These are not end grain cutting boards.  I haven't gotten that brave yet.  Knowing that I could nick a knife will keeping using the drum sander. 

Thanks for the info.

Josh

Posted

Not gum up but I've heard that a glue line can nick you knives. I have not noticed that and I send glued up panels through my planer all the time.

I think of more concern is that if you're making end grain cutting boards, sending them through the planer can cause the board to break to pieces (a very dangerous situation).

Edit: Using the drum sander as you have been is the usual method.

depending on what kind of planer you have and how cheap knives are,you may consider the planer yet. I plane all of my cutting board blanks before crosscutting and do scrape the glue but don't freak out about it. I proabably get 90% off. I then run it through the planer. Out of the 30+ boards I've made this last two months,  I don't have one blade knick and the blades are still sharp enough to not be tearing out on ppl heart.

Posted

I have planed a lot of glued panels and edge grain cutting boards, with never a nick to my blades. Tried to joint an edge on plywood once, that was a different story. Commercial plywood adhesive is apparently made from diamonds.

Posted

These are not end grain cutting boards.  I haven't gotten that brave yet.  Knowing that I could nick a knife will keeping using the drum sander. 

Thanks for the info.

Josh

When you do make an end-grain cutting board - DO NOT send it through the planer.  Chunks can split off and then become projectiles, harming you, your shop and your planer. 

Posted

When you do make an end-grain cutting board - DO NOT send it through the planer.  Chunks can split off and then become projectiles, harming you, your shop and your planer. 

Even worse if you've got carbide cutters cause they can shatter causing a chain reaction, so I've heard.

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Who's Online   1 Member, 0 Anonymous, 56 Guests (See full list)

  • Forum Statistics

    32.1k
    Total Topics
    437.6k
    Total Posts
  • Member Statistics

    26,008
    Total Members
    3,644
    Most Online
    Bob44
    Newest Member
    Bob44
    Joined