Popular Post Trip Posted January 2, 2016 Popular Post Report Posted January 2, 2016 Chopping some half-blind tail sockets in a high-figure (and particularly dense) White Birdseye pinboard, when I notice an ever-so-small chip in the chisel's microbevel (we’re talking 1/128) – barely enough to see... Now, I know that I should switch chisels – it’s not like I don’t have some hanging on the wall less than three feet away... But I’m in a groove, got less than an 1/8” to go, it’s the perfect chisel for the job --- and I’m particularly lazy... I don’t even make it to the bottom of the socket when a ragged chunk of steel is left embedded in the board... Cursing moderately, I now decide it’s a good time to switch chisels... So what happened?: One disadvantage of the harder metallurgies is increased tendency towards catastrophic edge breakdown (failure)... Traditionally, you encounter this with Japaneese laminated-steel chisels (you never pry with one), but it also occurs (just not as readily) with the increasingly-common A2, cryo-A2, PMV-11, etc... It's the primary reason why mfg's recommend a 30d secondary with these metallurgies... Note: narrow A2, cryo-A2, PMV-11, etc chisels should be treated like Japanese laminated steel chisels: 30d flat primary bevel, no secondary and no hollow-grind... So lesson learned: When you see that first tiny chip, stop and save the hassle of a regrind... 7 Quote
sjk Posted January 2, 2016 Report Posted January 2, 2016 You clearly need a Chisel Assistant who, like an OR nurse, will hand you tools. Quote
Llama Posted January 2, 2016 Report Posted January 2, 2016 1 hour ago, sjk said: You clearly need a Chisel Assistant who, like an OR nurse, will hand you tools. I can see it now. 1/2 chisel... assistant hands HHH a 1/2 chisel. HHH throws is the assistant, NO NO NO, the OTHER 1/2 chisel!!! But, you have 6 of them! YOU'RE FIRED!!! *Music trivia time! Which guitarist actually did this on video? (and wasn't kidding!) Quote
Tom King Posted January 4, 2016 Report Posted January 4, 2016 One of my helpers actually does get tools. Way back soon after he first started working for me, he started carrying driver bits in his pocket. I knew he would be a good one then. Last week I called for a T40, and I pretended to be miffed that he didn't have one, but not for long. We had a good laugh. Quote
sjk Posted January 4, 2016 Report Posted January 4, 2016 Wait - has anyone ever seen Tom King and HHH in the same place at the same time? 2 Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.