If you have had kickback, how did it happen?  

43 members have voted

  1. 1. If you have had kickback, how did it happen?

    • Bound between blade and fence
      16
    • Tension in wood gripped the blade
      8
    • Accidental contact with blade
      8
    • Other
      11
  2. 2. Have you ever had a kickback?

    • Yes
      35
    • No
      8


Recommended Posts

Posted

I voted no, but lied. I have ripped several million feet of foam board. I have had many return to me...but with no real kicking force. I asked for every one through absolute negligent cramming across the job site table with 4x8 sheets of floppy. Didn’t figure that counts. 

  • Haha 1
Posted
11 hours ago, RichardA said:

while sitting absolutely still, it'll hurt for a while, then go away.

Just reminding you that it is still there.

Posted
24 minutes ago, shaneymack said:

I have never had one and hope I never will. Now the router table, that's a other story....

Agree, the pucker factor doing some cuts on a router table with a 3.5hp router is way higher than the table saw! The use of the pivot pin brought that pucker factor way down though........thanks Eric!

  • Like 1
Posted
On 9/21/2017 at 9:52 PM, C Shaffer said:

“Other” will be skewed as the poll forced an answer to question one from those of us who answered “no” to question two. 

Was not aware of that fact. 

Posted
On 9/23/2017 at 3:51 PM, shaneymack said:

I have never had one and hope I never will. Now the router table, that's a other story....

Part of this thread was inspired by @thewoodwhisperer's story about running a piece on the router table, climb cut, between the fence and the bit.....  Spear chucker FTW. 

  • 3 weeks later...

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Who's Online   3 Members, 0 Anonymous, 33 Guests (See full list)

  • Forum Statistics

    32.1k
    Total Topics
    437.6k
    Total Posts
  • Member Statistics

    26,008
    Total Members
    3,644
    Most Online
    Bob44
    Newest Member
    Bob44
    Joined