MrMayor Posted April 10, 2021 Report Posted April 10, 2021 I have a Dewalt 12" chop saw that sticks when moving it to one of the 45 degree angles. Thoughts on how to make it move smoothly? Any videos you recommend? Quote
Coop Posted April 11, 2021 Report Posted April 11, 2021 Is it mounted into a table or taken out of storage like mine when needed? Quote
Mark J Posted April 11, 2021 Report Posted April 11, 2021 Does the sticking have anything to do with the detents at 45*? Quote
Tpt life Posted April 11, 2021 Report Posted April 11, 2021 I assume this the bevel and not the table pivot? Quote
MrMayor Posted April 11, 2021 Author Report Posted April 11, 2021 It is not the bevel, but the side to side. I just watched a video where they replaced the travel ring under the motor mechanism. Probably what I will do as it seems pretty easy to do. Thoughts? Quote
Tpt life Posted April 12, 2021 Report Posted April 12, 2021 I have seen many of these saws wear out without needing that to be done. That said, lemons do get released from time to time. How confident are you that you do not have dust built up? On the job, I am used to seeing these saws sprayed with compressed air from time to time. Quote
Chet Posted April 12, 2021 Report Posted April 12, 2021 6 hours ago, Tpt life said: I am used to seeing these saws sprayed with compressed air from time to time. This is always a good plan "A", then you can move on to things that may cost money. Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.