Popular Post BonPacific Posted May 12, 2022 Popular Post Report Posted May 12, 2022 I made myself an espresso tamper a couple years ago, but the original walnut handle I made broke off not long after. I set it aside planning to fix it in a day or two... Fast forward about 14 months and I finally got around to turning a new handle. About as simple a project as they get, but eminently satisying nonetheless. Especially since I'll be using this thing 2-3 times a day. Just a simple chunk of curly maple epoxied to the existing tamper base. The base is made out of some old brass roundstock I inherited from my grandfather and had laying around. It's a bit dinged up from clamping it back into the jaws of my chuck, but I didn't have a great way to clean up the sides afterwards. 5 Quote
Coop Posted May 12, 2022 Report Posted May 12, 2022 Very well done. I would probably put it to better use as a beer tap! 2 Quote
Mark J Posted May 12, 2022 Report Posted May 12, 2022 One trick I've used to keep jaws from marring is to use a wide rubber band to protect the finished surface. This only works for light cuts, like carefully removing a bowl tenon or sanding, though. Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.