Beechwood Chip Posted September 7 Report Posted September 7 A friend just moved into a rental apartment and found that parts of an exposed brick wall are shedding brick dust onto her furniture. It's an exterior wall. I assume that it's a brick wall, not brick veneer over some other construction, based on the age and location of the building. Any suggestions? Quote
Ron Swanson Jr. Posted September 7 Report Posted September 7 Not really. If it were me, I imagine my approach would be pretty close to the following: * Use shop vac to suck as much loose dust as possible * Use air compressor and try to dislodge any remaining dust. Vacuum again. * Give the entire wall a through wipe down with wet rags. * Repeat once or twice a year as needed 2 Quote
Ron Swanson Jr. Posted September 7 Report Posted September 7 On 9/7/2026 at 6:18 PM, Von said: Internet suggestion ahead: Shellac? I was wondering about that too, but for some reason, me and my vast knowledge of masonry (none) have it in my head that brick needs to be left alone so it can absorb and expell moisture evenly. I have absolutely no idea if that's even remotely true or not. 2 Quote
Popular Post wtnhighlander Posted September 8 Popular Post Report Posted September 8 Given that it is a rental, re-arranging the furnituremay be the most acceptable option. 4 Quote
Popular Post Beechwood Chip Posted September 8 Author Popular Post Report Posted September 8 I think she's going to try removing the loose dust with a wire brush, compressed air, shop vac, and maybe wet rags, and then see about getting an estimate / diagnosis from a mason and talking to her landlord. I suspect that there's a roof leak or gutter problem or brick pointing problem somewhere. Unfortunately, moisture can travel inside a brick wall so it can be hard to locate the source of the trouble. In my house, there are three kinds of brick. The outside of the front of the house was made with fancy show bricks, very hard, designed to resist weathering, very uniform and good looking. The outside of the back of the house was made with less fancy bricks that were still designed to resist weathering. The walls of a brick house are usually two or three bricks thick at the top and can be four or five bricks thick at the bottom. The inner brick are inexpensive, soft, crumbly bricks that won't squish but are otherwise weak. Since the inner walls would be plastered, the inner bricks were the inexpensive kind. So, "exposed brick" is not always the good idea it seems to be. 3 Quote
Tom King Posted September 8 Report Posted September 8 There will be no end to dust coming off that wall. It looks to me to be an exterior wall that's letting enough moisture through it to keep leaching lime out of the mortar. Also a possibility, those old brick walls are just flexible enough that strong winds will move the building enough that it will shed brick shards or brick dust. If it's not an exterior wall, some water may be entering it from above. Moving the furniture is the best option, barring coating the wall with something, but even that will be a long term losing proposition. 2 Quote
Beechwood Chip Posted September 9 Author Report Posted September 9 On 9/8/2026 at 11:25 AM, Tom King said: leaching lime out of the mortar I asked if there was any white powder and she said it's all red brick dust. It is an exterior wall. I agree that there's moisture moving through the wall, and the fix will be roofing, pointing, or flashing if lucky, otherwise rebuilding the wall. Weirdly, there's no window in that wall, but there is a window one floor below. And there's some sort of vent in the wall. I suspect some kludgy work when central heating was installed. I don't understand how there can be a vent in an external brick wall, unless it's an exhaust vent for a dryer or a bathroom. I haven't seen this yet, but I'm dying to take a look at it. Quote
Mark J Posted September 9 Report Posted September 9 As others have said, move the furniture, but maybe she should be moving the furniture to another apartment. 1 1 Quote
Tom King Posted September 10 Report Posted September 10 Brick dust means the wall is swaying and pressure breaking off little bits. It's not going to stop baring some major work. 1 Quote
Beechwood Chip Posted September 10 Author Report Posted September 10 What do you think about using epoxy paint to seal the surface? Quote
Von Posted September 10 Report Posted September 10 I feel like I should give my typical answer to a finishing question: try it in a small, out of sight area, and see what you think. That's being cavalier with long-term moisture movement concerns but I have no idea how to address those. 1 Quote
pkinneb Posted September 10 Report Posted September 10 On 9/10/2026 at 10:52 AM, Beechwood Chip said: What do you think about using epoxy paint to seal the surface? I think the problem, like Tom pointed out above, is it sounds like their is still moisture getting in from the back side, if correct that doesn't bode well for any finish. 1 Quote
Tpt life Posted September 11 Report Posted September 11 Lime plaster might do ok. That would change the nature of the surface though. 1 Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.