Recommended Posts

Posted

first post to "The critique room"

Here is a butch block "table" i made for a clients customer. Includes knife storage (cherry strip). There is also a cherry strip in the sides, covering a mistake of cutting into the alignment biscuits.

Client wanted to keep it affordable. So I used construction lumber for bottom... hard maple for the top.I would have liked to make the top thicker but for the budget the client gave me i couldn't afford to do so. I also though that a few slats on the bottom to make a storage shelf would have been nice.

post-2720-0-11434300-1344193804_thumb.jp

post-2720-0-79391900-1344193804_thumb.jp

post-2720-0-35969000-1344193805_thumb.jp

post-2720-0-95617700-1344193805_thumb.jp

post-2720-0-52799200-1344193806_thumb.jp

post-2720-0-63364700-1348684642_thumb.jp

  • Like 1
Posted

The table looks good, I like the way you covered your tracks i.e. the biscuit oops. I remember you asking about magnets for the knife slot, so is it magnatised, or just a slot looks nice either way just currios.

Posted

reminds me of a project i made for brother in law. it is a traveling cuting board with a section for spices, and a slot in the back for the knife. i added magnets just to make shure the knife did not slide out while being carried outside. wanted something he could use next to the grill and then bring in to clean.

Posted

Table looks nice! I agree that a couple of slats would work on the lower shelf... maybe if you did up a small square with 3/4 slats and 3/8 spacing, and a small square to fit inside, you could call it a serving tray -slash - shelf? Think the client would spring for another $50 -$100 for additional function?

(Not like the table needs it. Just thinking out loud, as it were. Nicely done!)

Posted

I think it looks very nice! The fix is awesome and I love the knife slot. How exactly did you make that slot? It is great.

S Barton,

I took a slice of cherry longer than my final piece. I cut out one slice for the side, then adjusted the rip fence to around 1/8 (this will determine the slot width)... I then cut another slit for the other side. Around 1/4" for the sides.

I cut the ends off the center piece, about 4-6" and glue them. (leaving out the middle to create the slot)

Hope that made sense!

  • 3 weeks later...
Posted

I thought about this as well, and assumed it was a standard thing since no one else mentioned it.

I just hate the idea of knives hanging below the top - makes me shiver!

  • 3 weeks later...
  • 3 weeks later...

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.