duckkisser Posted January 22, 2014 Report Posted January 22, 2014 im thinking about buying a set of these for myself. does anyone have some that can tell me what you think of it? did you find a cheaper place to buy them?do they work or not? http://www.woodcraft.com/Product/2001885/3608/BandRollers---Fits-Jet-and-Most-Imported-14.aspx or is cooling block good enough Quote
dwacker Posted January 22, 2014 Report Posted January 22, 2014 Im sure their fine but cool blocks are fine also and much less expensive. Quote
AceHoleInOne Posted January 22, 2014 Report Posted January 22, 2014 Save your money and apply to other wood fun. Cool blocks are ok on wide blades but small blades...not so good. I just didn't like them. They wear too much and found frequent dressing on the sander was necessary to square them back up. Put my stock steel blocks back in. Don't over-think it. -Ace- Quote
Hybrid-woodworker Posted January 22, 2014 Report Posted January 22, 2014 I used cool blocks for a while, lignum vitae blocks and oak blocks. Found they all worked the same, just different price point. I did finally upgrade to the Carter roller bearings and found they work well. I like the Carter's because they don't wear and once adjusted for a particular blade they stay adjusted. Never have used those in the link but they would not wear like the others, I never use metal blocks as in my mind they Would cause more heat. BRuce Quote
wdwerker Posted January 23, 2014 Report Posted January 23, 2014 I have had Carter guides on my saw for about 12-15 years. They work great and last! Quote
Tom King Posted January 23, 2014 Report Posted January 23, 2014 The first bandsaw I ever bought, and still have it, had Carter guides on it. The bandsaw and guides were used when I bought it some decades ago. I've never thought about there being any issue with them one way or another. They still work just fine. Quote
woodieboy Posted February 7, 2014 Report Posted February 7, 2014 I installed an aftermarket guide kit on my old saw , works well and last. Quote
STL Woodguy Posted February 7, 2014 Report Posted February 7, 2014 For those with Carters, do you have any trouble with the bearings shifting when tightening? I have supposedly "Carter-like" bearings on my bandsaw, but they drive me nuts as they shift slightly when tightening making it a trial-and-error affair. Looked into Carters but have seen some opinions saying they do the same thing, which wouldn't be much of an upgrade if they did. Quote
wdwerker Posted February 7, 2014 Report Posted February 7, 2014 I use a "T" handled Allen wrench to tighten mine. You have to get it in place and barely snug it first, get the other side in place and snugged, then go back and tighten them all. Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.