curved surface?

[-MattK-]

I'm playing around with a design for a curved piece - can't figure out how to fill in a curved surface.  The curves were designed using a center point and then two circles with different radii to get a piece with consistent width.  Any idea how to "close in" those open areas?

thank you!

 

. 

[Tpt life]

I think it is as simple as drawing a line across from left arc to right arc at the midpoint area. 

[-MattK-]

thanks man.  I tried that but it didn't work.  I'm now playing with creating the curved portion in 2d and the pulling it out to the width.

[Trip]

Suspect it's more about workflow... Draw one side and use push/pull would be my bet...

[-MattK-]

Yup, that was it, trip.  thanks to you both!