Skip to content
View in the app

A better way to browse. Learn more.

Wood Talk Online

A full-screen app on your home screen with push notifications, badges and more.

To install this app on iOS and iPadOS
  1. Tap the Share icon in Safari
  2. Scroll the menu and tap Add to Home Screen.
  3. Tap Add in the top-right corner.
To install this app on Android
  1. Tap the 3-dot menu (⋮) in the top-right corner of the browser.
  2. Tap Add to Home screen or Install app.
  3. Confirm by tapping Install.

What I learned from our machinist today.

Featured Replies

I was asking him about bandsaw bearing layouts, even though he only works with metal cutting. But he's been a machinist for decades so knows his stuff.

Was asking him about upper bearing guides and why some use a thrust bearing while others have the blade edge run against the rolling edge of the bearing. The answer makes perfect sense. When it's against a thrust bearing, as the bearing turns (2-surfaces are in contact with the blade) run-out is mitigated. But when it is against the rolling side of the bearing then you get the potential for run-out because pressure against the blade will cause it to twist to one side or the other. And run-out leads to drift & other problems.  (His metal-cutting bandsaw has only a pin behind the blocks to absorb pressure.)

Then we noticed, looking at some pics, that some upper bearings have a groove in them so that run-out is controlled.

There may be more to it, of course. But that's what I learned today.

***

Thrust bearing design

BSthrust.jpg

Groove

BSgroove.jpg

Edge, subject to run-out.

BSrun-out.jpg

I have one of each type.  They both perform well :). People make way too much voodoo out of bandsaw performance IMHO.

8 hours ago, gee-dub said:

I have one of each type.  They both perform well :). People make way too much voodoo out of bandsaw performance IMHO.

Gotta blame the results on somethin ;)

This makes no sense to me. You are never eliminating runout, you are only shifting that potential 90°. One runout potential is left right, and one is front back. That said, gee-dub nailed it. The bandsaw is not a finish tool. 

  • Author
1 hour ago, C Shaffer said:

This makes no sense to me. You are never eliminating runout, you are only shifting that potential 90°. One runout potential is left right, and one is front back. That said, gee-dub nailed it. The bandsaw is not a finish tool. 

Probably more a matter of degree than shift. The blade will contact the thrust bearing at two points instead of one. And since it's turning there will be a twist instead of a shift. That means movement but less than moving all to one side.

Still, if run-out is serious then one is absolutely pushing the wood too hard for the blade. That's the more significant issue.

Agreed: The bandsaw is not a finishing tool.

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

Forum Statistics

  • Total Topics 32.1k
  • Total Posts 437.6k

Member Statistics

  • 26,009 Total Members
  • 3,644 Most Online
  • Joseph b Newest Member ·

Account

Navigation

Search

Search

Configure browser push notifications

Chrome (Android)
  1. Tap the lock icon next to the address bar.
  2. Tap Permissions → Notifications.
  3. Adjust your preference.
Chrome (Desktop)
  1. Click the padlock icon in the address bar.
  2. Select Site settings.
  3. Find Notifications and adjust your preference.