Recommended Posts

  • 4 weeks later...
Posted

So I am getting ready to clean my blades and one of them looks to have a little rust on the face, can you just a green scouring pad and some mineral spirts and rub out the spot similar to cast iron?  Is there anything you have used with success to stop rust on the blades?  I am assuming you cannot use just the normal stuff so saw dust does not stick or so the lubricants don’t transfer to the wood. 

Posted
9 minutes ago, Woodworking_Hobby said:

So I am getting ready to clean my blades and one of them looks to have a little rust on the face, can you just a green scouring pad and some mineral spirts and rub out the spot similar to cast iron?  Is there anything you have used with success to stop rust on the blades?  I am assuming you cannot use just the normal stuff so saw dust does not stick or so the lubricants don’t transfer to the wood. 

I haven’t dealt too much with rust on my blades, but typically I use a green scouring pad with some Simple Green which cleans up my blade pretty nicely.

Posted
27 minutes ago, wtnhighlander said:

Scouring pad should be fine. I usually apply wax after cleaning my blades, either cheap floor wax, or leftover beeswax & mineral oil blend that I use for wooden kitchen ware.

Yea I was thinking I could use the same wax I used on my cast iron was just not totally sure 

  • Like 1
Posted
59 minutes ago, gee-dub said:

If that is rust it is most likely from residual moisture. If you live in an area that has actual weather compressed air can help you get things dry as a bone.

Thanks I will give that a try next time to make sure I got everything bone dry on the blade. 

Posted

Or, when the carbide tips finally wear down to the thickness of the blade, trying to cut thru some good hard maple will wear that residue right off. ;)

What you’re seeing in the pic shouldn’t be a concern. 

  • Haha 2
  • 2 months later...
Posted
On 10/30/2021 at 3:01 PM, gee-dub said:

If that is rust it is most likely from residual moisture. If you live in an area that has actual weather compressed air can help you get things dry as a bone.

I just cleaned my blade again this weekend as they had some good buildup from a few of my last workbench cuts on that deadman where you have to cut that v-notch in the bottom. The compressed air was a good call!!  I was surprised how much water came off of the blade even though it looked dry and was dried off with a towel. A lot of water came out of those little stress relief cuts in the blade and I will do this with them from now on!!

  • Like 2

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.