Cliff Posted May 28, 2017 Report Posted May 28, 2017 I understand you should use very light pressure on a spindle sander, but when I use mine it seems any more than the very lightest touch literally stops the spindle from rotating. I have that Rigid belt/spindle combo unit. I've only ever used the belt part of it until today. I'm not sure if it's got an issue or I just don't know what I'm doing. Anyone have thoughts? Quote
JohnDi Posted May 28, 2017 Report Posted May 28, 2017 Can check when I get home ,but it happened to me awhile ago. i think that it was because when changing from the belt to the spindle I forgot to put the washer below the spindle? Quote
Eric. Posted May 28, 2017 Report Posted May 28, 2017 Is the spindle actually stopping or is the sleeve just slipping on the drum? If it's the latter, there should be a nut at the top of the spindle, and when you tighten it, it compresses the drum and makes it fatter, and therefore tightens the fit of the sleeve. Sent from my SCH-I545 using Tapatalk Quote
pkinneb Posted May 28, 2017 Report Posted May 28, 2017 Eric is right on here. I bet its slipping on the drum. Quote
drzaius Posted May 28, 2017 Report Posted May 28, 2017 Ya, you should be able to put a fair bit of pressure without stalling the sleeve. Tighten the rubber drum. Quote
wdwerker Posted May 29, 2017 Report Posted May 29, 2017 The washer and a fairly tight nut are nessacary. A big shop vac helps but it is a messy tool. Quote
Cliff Posted May 29, 2017 Author Report Posted May 29, 2017 I think you guys solved it. I can guarantee I didn't put a washer on. I had no idea. Cause if I read the directions, it was 2 years ago! I'l try it tomorrow. Thanks guys! Quote
wtnhighlander Posted May 29, 2017 Report Posted May 29, 2017 Unless you are using the skinniest sleeve, that fits right on the shaft. No rubber to expand and tighten, so it spins easily. Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.