pkinneb Posted January 28, 2018 Report Posted January 28, 2018 Really nice! Thanks for taking the time to share. 1 Quote
..Kev Posted February 22, 2018 Author Report Posted February 22, 2018 I know it's been a while since posting this project but, I've made an upgrade to it and wanted to share. I noticed that with wood movement, some of the bits were difficult to get out so, I've added the Rockler inserts to it. In hindsight, I should have changed my spacing on a couple that I made but, I'm really happy with the inserts! Makes the bits much more consistent for getting them out and putting them in. They take both 1/4" and 1/2" shanks. Requires a 5/8" hole and spacing should be a minimum of one inch. Here's the inserts - http://www.rockler.com/rockler-router-bit-storage-inserts-10-pack 1 Quote
Chet Posted February 22, 2018 Report Posted February 22, 2018 Are you talking about one inch on center? Quote
..Kev Posted February 22, 2018 Author Report Posted February 22, 2018 4 minutes ago, Chet said: Are you talking about one inch on center? Yes.. Keep in mind that's minimal spacing for the inserts.. If your bits are bigger than that, then you'll need to allow for them. Quote
Chestnut Posted February 22, 2018 Report Posted February 22, 2018 Do you think movement in ply would cause this issue? Quote
..Kev Posted February 22, 2018 Author Report Posted February 22, 2018 Just now, Chestnut said: Do you think movement in ply would cause this issue? No, I don't think that would be nearly as big an issue as the hardwood. Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.