Pwk5017 Posted April 26, 2018 Report Posted April 26, 2018 Certainly took me long enough, but finally found the right lot of cutterheads for my saw/shaper I’ve had for 6 months. Up until now I’ve been using the high speed router spindle to use my existing router bits. After a few months of looking, I picked up 30 insert cutterheads last week. All American made steel tooling with replaceable carbide knives. Here’s a comparison with a 1/2” shank round over bit. Each one is shockingly heavy, about 20lbs. Might be one of those times where you fire up the machine and duck n cover. Quote
Coop Posted April 26, 2018 Report Posted April 26, 2018 I reread it 3 times. 20 lbs. each? What the heck turns them, a corvette engine. What are these used for? Quote
mat60 Posted April 26, 2018 Report Posted April 26, 2018 The removable cutter heads scare the crap out of me. Are you going to make molding. Quote
wdwerker Posted April 26, 2018 Report Posted April 26, 2018 Fairly big motor and all that mass spinning slower than router bits do equals torque to make clean cuts on larger surfaces than router bits. Quote
Pwk5017 Posted April 26, 2018 Author Report Posted April 26, 2018 Those particular heads are for making interior and exterior doors, I believe. This is one of the 12 cope and stick cutterheads for cabinet doors. Probably 5” diameter and 5-7lbs. The first ones are about 8” in diameter, and honestly pushing the max my machine can handle. I don’t know if felder specifies max weight, but the max diameter it can handle is 9”. It’s a 5hp motor, which is also on the lighter end of the spectrum for huge tooling. Very interested in comparing the cut quality of expensive equipment with a power feeder versus a hand fed router table. This is easily the most expensive tool I’ve come across. The machines themselves aren’t cheap, and then you really can’t operate them efficiently or safely without a feeder($900 for a cheap one), and finally the cutters are the icing on the money pit cake. Expectations are high. 1 Quote
Chestnut Posted April 26, 2018 Report Posted April 26, 2018 So reading between the lines .... go to millwork yard, buy door. Take Door home. Install door. I've always wanted to see what a shaper was like to use but i don't use my router table much as it is Quote
wdwerker Posted May 2, 2018 Report Posted May 2, 2018 Shaft speed with that diameter cutterhead should create higher speed at the actual cutting edge shouldn't it ? Definitely a situation where a powerfeeder is required. Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.