Coop Posted October 11, 2018 Report Posted October 11, 2018 I’ve had some pecan and walnut slabs stickered outside now for going on 4 years. They are on cinder blocks, up off a concrete slab and stickered. I built a 1x frame around them with landscape fabric on the sides and corrugated metal across the top. About every 6 months or so I have to replace the fabric due to the elements. IMO, it’s dried all it’s going to and I would like to move them inside the building at my work. There is a second level where they would be out of the way. The air up there is not stagnant like a house attic but there is not a lot of air movement, compare it to like a barn with the doors closed. If I continue to sticker them, is there a concern about there not being much air movement as they are already dry? I’d hate to screw them up now after nursing them this long. Quote
..Kev Posted October 11, 2018 Report Posted October 11, 2018 Check the moisture content and see if it's relative to the rest of the lumber in your shop. If they're dry, move them in. 1 Quote
Bmac Posted October 11, 2018 Report Posted October 11, 2018 Coop, how thick are the boards? After 4 years outside, you should be fine to move them, and I don't think you need to worry much about air movement at this stage, unless the slabs are super thick. Air flow is really needed for the initial drying stages when you are worried about mold and fungus growth. It's my understanding and experience that mold growth or fungal growth will not take place in wood that is air dried to the local EMC. Mold will not grow in wood with moisture content of less than 20%, fungi need even higher moisture content to thrive. I'm pretty confident your lumber is at your local EMC at this point and if you store it in a sheltered unconditioned space that has no heat/ac, the wood's emc will likely change very little if any at this point, air flow or no air flow. 1 Quote
Spanky Posted October 11, 2018 Report Posted October 11, 2018 Coop if your slabs are 8/4, I don’t think you need to worry. 1 Quote
Coop Posted October 11, 2018 Author Report Posted October 11, 2018 Thanks guys. Yes they are all 8/4 so inside they go. I will check the moisture content just to be on the safe side. Quote
wdwerker Posted October 11, 2018 Report Posted October 11, 2018 Did they stay dry during the flood a while back ? Check the moisture in multiple places on each slab. If they have always been stacked in the same order it might be interesting to see if the middle ones are as dry as the top & bottom slabs. Quote
Chip Sawdust Posted November 2, 2018 Report Posted November 2, 2018 I’ve been able to dry my small amounts inside my garage so that hasn’t been an issue but if your moisture is good outside, I see no reason it could get worse going inside. Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.