Recommended Posts

  • 3 weeks later...
Posted

Some initial thoughts on the woodpecker drill press table.

0820585F-B9DA-43A2-ABA7-2B6A5DB8A34A.thumb.jpeg.b02e29153292b8b7ee47c751b441dc4a.jpeg

026CB0E5-4C0E-4889-944B-A308867BF3D9.thumb.jpeg.d12bed5a7ce380a17037179e60882334.jpeg

06921D5C-1192-4644-9359-956A0AB35C43.thumb.jpeg.28508b0fd0bf8ceec5b9701a6fdf3450.jpeg

I like the insert. Finger holes are convenient. There are 4 screws under for levelers. I may change the screws to a bigger diameter. Not enough resistance. 1/2" mdf is recommended by woodpecker. I like the idea but I have none. So I used 1/2" ply. I ripped a piece around 2 ft. long slightly wider than needed. Once I found the perfect dimension on the table saw I was set. Using the same set up I cross cut for a perfect fit. With the set up I cut several.

I have not used the fence or the hold downs but they look adequate. The metal rails are bolted from below. Important as the hold downs are attached to the rails. If it was screwed instead of bolted the hold downs could pull it up.

  • Like 1

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Who's Online   1 Member, 0 Anonymous, 50 Guests (See full list)

  • Forum Statistics

    32.1k
    Total Topics
    437.6k
    Total Posts
  • Member Statistics

    26,008
    Total Members
    3,644
    Most Online
    Bob44
    Newest Member
    Bob44
    Joined