Recommended Posts

Posted

6e4755df4848a8f39e34f13e99c77787.jpgd0a85a8df6d99c2415e5237f352ded2a.jpg

In 2015, I resolve to conquer my fear of the far side of the lathe, i.e. turning interiors. I'm working the inside of what will be the top of an open, segmented vase. Dry Douglas Fir (because that's what I have at hand) and some bits of red oak at the rim and base. Pedestrian materials to be sure, but I'm learning a lot.

Full disclosure: My first attempt at hollowing went badly. I got kicked around and scared s###less every time the tool caught, so I put what was left of the workpiece (a small, segmented pot) aside and took a break. Richard Raffan's book finally helped me figure out what I was doing wrong. Back in the saddle we go. The interior of the top is shaped and scraped with (knock on wood) nary a catch thus far.

Sent from my iPhone using Tapatalk

Posted

It is scary, no doubt. But the key is understanding how a catch occurs. Citing Raffan's book:

16f9444df79ad4786408dac43280d544.jpg

This was the epiphany. All of my catches had been on inside walls where the surface was nearly parallel to the axis of rotation. It seems so obvious now. I had had the gouge rolled to its right side and it contacted the wood on the left. Catch, twist and BANG! all in the blink of an eye.

Sent from my iPhone using Tapatalk

Posted

I'm in between shops right now. Chop saw, both table saws, the drill press, the planer, etc...all the big stuff still hasn't made the move. For now I have an Irwin pull saw and a block plane.

Sent from my iPhone using Tapatalk

Posted

Turned the interior of the bottom. Major milestone: I glued the top half onto the bottom half! No turning back now.

7d55e42ad13b597921ffdf8b2d63d34b.jpg

I knew there was a reason I have all those heavy woodworking books in my library.

Sent from my iPhone using Tapatalk

  • Like 1
Posted

0a11e96bcf6e79973ef84c481607cca3.jpg

Up to speed and starting to take shape. It didn't shatter into a thousand pieces during the initial chattering cuts to knock off the edges. So far, so good.

Sent from my iPhone using Tapatalk

Posted

Getting very close to the final shape for the bottom. The nice thing about an open segmented form is that you can constantly check your wall thickness. The bad thing about an open segmented form is that your wall thickness must be absolutely uniform or it'll look awful.

1ddde94340a9e89cc60f3d2328b1cab4.jpg

Sent from my iPhone using Tapatalk

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.