Knox wood Posted March 9, 2017 Report Posted March 9, 2017 Hey guys. Some of you guys may remember me posting for some help on how to make a small boxes 45° ends line up, and how get it perfect. Well, I decide to hell with that& go big or go home!! So I made a bench. Now it is not perfect square at every corner by any means, but it looks damn better than that box I was trying to build, and it hasn't broken yet when sitting in it! Anyway.. thank you guys who e helped me thus far.. and any tips or pointers on how to make this bench better bedtime are totally welcome! Next time** this is made from plain common pine board at HD, although the posts are Douglas fur(all they had)... I just used a polycrylic spray clearcoat to finish. Just a used screws to fasten, no fancy joints. 1 Quote
Eric. Posted March 9, 2017 Report Posted March 9, 2017 A few things you can do to vastly improve that project would be to learn the mortise and tenon joint; learn how to make a panel and how to properly attach it from beneath; and finally, find a real hardwood dealer and buy some quality lumber. Nice effort. Sent from my SCH-I545 using Tapatalk 2 Quote
drzaius Posted March 9, 2017 Report Posted March 9, 2017 That is a nice effort on your first project. And Eric, the curmudgeon, has some good suggestions on where to go from here. Looking forward to seeing your next project. 2 Quote
Popular Post Eric. Posted March 9, 2017 Popular Post Report Posted March 9, 2017 He asked for tips how to make the next one better... Sent from my SCH-I545 using Tapatalk 3 Quote
drzaius Posted March 9, 2017 Report Posted March 9, 2017 And you did. Nothing wrong with being a curmudgeon. 2 Quote
BonPacific Posted March 9, 2017 Report Posted March 9, 2017 Good effort Knox. Getting that first project out always feels good. How many coats of the polycryclic did you apply? Quote
..Kev Posted March 9, 2017 Report Posted March 9, 2017 Good start! Apply the lessons learned, learn some new techniques, and then go for it again. 1 Quote
Llama Posted March 9, 2017 Report Posted March 9, 2017 I burned my first project, so you aren't doing too bad! 1 Quote
Knox wood Posted March 9, 2017 Author Report Posted March 9, 2017 3 hours ago, BonPacific said: Good effort Knox. Getting that first project out always feels good. How many coats of the polycryclic did you apply? I just had 1 minwax can and did about 4 total.. used up whole can... coat, sand with 220,, coat, sand, then last sand was 320, then final coat Also, I have limited tools... for this I had to borrow my buddy's table saw to rip the boards to width... I cut the posts with a hand saw... then just a square palm sander.. 2 Quote
Ronn W Posted March 9, 2017 Report Posted March 9, 2017 That's a great first project, Your journey has begun. 1 Quote
wtnhighlander Posted March 10, 2017 Report Posted March 10, 2017 Knox, the first thing I recommend to improve the next project is to invest in an accurate square, an X-acto knife or true marking knife, and build youself a sturdy workbench. Constuction like you used for this project will hold for a good while. Just don't use drywall screws! Then decide if you want to build a power tool shop, or stay with only hand tools. That decision will inform the next choice of tool. Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.