baok Posted June 10, 2013 Report Posted June 10, 2013 What tool do you use to get saw nuts loose? The slots are too narrow for any screwdriver I have. Quote
TRBaker Posted June 10, 2013 Report Posted June 10, 2013 Ah.......could you be a little more specific? Quote
Tpt life Posted June 10, 2013 Report Posted June 10, 2013 The grind on the ends of this pry bar is about that of a dull chisel. Works well in traditional narrow slots. Quote
CessnaPilotBarry Posted June 10, 2013 Report Posted June 10, 2013 I made a notch in the center of a large flathead screwdriver with a hacksaw, then cleaned it up with needle files. Lie Nielsen sells a saw nut screwdriver, but I haven't seen the need to swing for one. Quote
baok Posted June 10, 2013 Author Report Posted June 10, 2013 Update: I took this saw to the saw vise last night and filed and set the teeth. This was kind of boring but very rewarding. It gave me a chance to use that Veritas saw filing guide I bought a few weeks ago as well as get some practice. With me, it is as much a practice in patience as practice in filing. I know that the common wisdom would be to take the saw apart and clean it all before filing but my patience left me and I wanted to accomplish something. The tooth line was pretty seriously out of joint so that’s why it took me as long as it did – after jointing, some of the teeth were half gone. It cuts pretty well now (compared to the dullness of before) and when I look at the teeth in better light, I can tell that a few of the teeth still have some tiny flat tops from the jointing. I can justify going over the teeth again once I get it clean. I took it to work and asked our machinist what he would do to get the saw nuts loose and he suggested grinding a putty knife to make a tool. That way, the tool wouldn’t be so hard as to bugger up the brass screws. Fun stuff. I have some tenons to cut so I need to get on this soon. I’m glad I bought that grinder recently. Quote
nateswoodworks Posted June 11, 2013 Report Posted June 11, 2013 When i built my DT saw I did almost the same as Barry but I used a screwdriver bit instead of a whole scredriver. I did it thiat way because it was cheaper and takes up less space to store (i have my drawer laid out perfect with dividers and didnt want to alter it for a screwdriver i almost never use) A putty knife may work as long as its a very stiff one, otherwise I'm afraid it's just going to bend the steel. You have to remove all but two little wings which is going to make something like a puddly knife very weak. Just my two cents but its something you may want to think about. Quote
Don Z. Posted June 11, 2013 Report Posted June 11, 2013 Tools for Working Wood sells a socket wrench that works: http://www.toolsforworkingwood.com/store/item/GT-SNSD/Search/saw%20nut/The_Gramercy_Tools_Split_Nut_Driver Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.