Beechwood Chip Posted July 17, 2015 Report Posted July 17, 2015 How important is it that stationary power tools be level? Usually, the assembly instructions say, "adjust the feet so that the tool is level." But, my basement shop has a cement floor that slopes down towards a drain at one end. And, my tools are on mobile bases. So, unless I adjust the feet after moving and locking the base, it's not going to be level. I figure that nothing needs to be perfectly level except for my assembly table. You guys who work in a garage and roll your tools out onto the driveway must have the same issue. Is it a problem? Quote
Barron Posted July 17, 2015 Report Posted July 17, 2015 I have never worried about it as long as my tools don't roll of the top. Quote
RichardA Posted July 17, 2015 Report Posted July 17, 2015 I think that's a guideline, most stationary machines have flat tables to work on, level in this case is more for control of the material your doing something to! Though level is always better, the flat surfaces of the machinery compensate for out of level. Quote
shaneymack Posted July 17, 2015 Report Posted July 17, 2015 Must garage floor is pretty jacked up. I "somewhat" leveled my table saw and my big bandsaw. All the other stuff i didnt even check. Quote
Trip Posted July 17, 2015 Report Posted July 17, 2015 Depends on the equipment and how ‘not-level’ we are talking about... Some stationary sanders use oil reservoirs for lubrication – I think two of mine do... Some planer designs also have oil-reservoir gear boxes... Those need to be somewhat level, probably < 5d. It would be in the manual... Quote
drzaius Posted July 17, 2015 Report Posted July 17, 2015 My garage floor slopes 3" in 26' & I've never seen a need to level the tools. Although the mobile base on my new SawStop is so good that when I engage it the saw wants to roll away from me. Quote
Immortan D Posted July 17, 2015 Report Posted July 17, 2015 If the tool came with just one adjustable feet, as most tools do, I think "level" has to be read as "not swinging" that's all. Quote
Tpt life Posted July 17, 2015 Report Posted July 17, 2015 I don't want a level table saw in a pitched driveway. I want it parallel so that long stock is at a comfortable level all through the cut and the outfeed aids do not need to be adjusted. I have not noticed any different wear between shop levels tools and those used on the driveway. Quote
wtnhighlander Posted July 17, 2015 Report Posted July 17, 2015 It all depends in where you place your pencil. Behind the ear, in a pocket, level doesn't matter. 1 Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.