Recommended Posts

Posted

So the bar that holds the blade guard is right in the way for the rear rail... I'm tempted to just chop the thing off since I don't use the blade guard on this anyways.

Thoughts?

3323743afe59bfccfe063cb8d0190759.jpg

I tried to just remove it but it seems to go all the way through the saw and part of the motor bracket is also attached where it is so I'm not sure if I'll screw up the alignment or something.

Posted

I don't think I'd do that given the likelihood that the saw may be sold down the road. The rear rail is angle or box right? It should drill with minimal loss of integrity. 

Are you sure it cannot be removed?

Posted

Find the center carefully, make a divot with a center punch, use a small bit to start with and a drop of oil. Using successively larger bits and oil will make it easier to drill the back rail. Clamp the rail firmly to the drill press table before you drill. You need mild to medium pressure and medium to low speed on the spindle.

  • Like 2
Posted

I have nothing but good things to say about the Vega Pro 40 I had on my old saw. I had a couple issues with it when I first went to install it years ago but a phone call to Vega got me all the help I could possibly want. I am sure you will be very happy with it.

  • Like 1
Posted

+1 on the customer service ! 

I called once when I was readjusting the fence after years of use and the owner talked me through it and sent a few replacements for parts I had used/abused.

  • Like 1
Posted

So far I've found that this fence works just fine without the rear rail (which only seems to keep the fence from popping up while locking and to allow wider rips) and I can work with that until I can get it drilled out. Once locked, it doesn't deflect at all.

However, I can't get the thing to be parallel to the miter slots to save my life. How the hell do you adjust these?

Front:

d1a446883e7dc1b55772e390551b3034.jpg

Rear:

28868edbce0c6c7d61e635f0186c20ab.jpg

Posted

After looking into things and pricing a bit that might be able to drill that rear bar, I'm just going to bring it to work tomorrow and have the manufacturing floor here do it. It'll take them about 5 minutes with their big drill press and then if it gets screwed up I can blame them :P

  • Like 2

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Who's Online   3 Members, 0 Anonymous, 68 Guests (See full list)

  • Forum Statistics

    32.1k
    Total Topics
    437.6k
    Total Posts
  • Member Statistics

    26,008
    Total Members
    3,644
    Most Online
    Bob44
    Newest Member
    Bob44
    Joined