Rex Edgar Posted March 8, 2016 Report Posted March 8, 2016 I've had a few old hand planes around the shop for some time now. Internet being what it is, I have looked at many 'instructionals' on the web. I want to try to get them as a daily used tool in the shop. I have seen planes used many times in leveling dove tails and plugs used to hide fasteners, usually a piece of a dowel. Before I try this method, I wanted to hear from experienced people, how this works. I can't help but think that a tool working against end grain will tear out the wood. Are my fears valid and what is the preferred method? Quote
wtnhighlander Posted March 8, 2016 Report Posted March 8, 2016 Really, really sharp. Bevel angles make a difference too, but sharp is key. 1 Quote
Chestnut Posted March 8, 2016 Report Posted March 8, 2016 I also work from the edge inwards. It's hard for wood to r Tear out when it has support. Sharpen well and often, makes it easier. Pardon the spelling sent from my phone. 1 Quote
RichardA Posted March 8, 2016 Report Posted March 8, 2016 What Highlander said... low angle, and sharp, very sharp! Quote
wdwerker Posted March 8, 2016 Report Posted March 8, 2016 Everything said above plus try to take the thinnest shavings possible. If you can't work away from outside edges clamp a board on to back up the cut. 1 Quote
Immortan D Posted March 8, 2016 Report Posted March 8, 2016 5 hours ago, Rex Edgar said: I've had a few old hand planes around the shop for some time now. Internet being what it is, I have looked at many 'instructionals' on the web. I want to try to get them as a daily used tool in the shop. I have seen planes used many times in leveling dove tails and plugs used to hide fasteners, usually a piece of a dowel. Before I try this method, I wanted to hear from experienced people, how this works. I can't help but think that a tool working against end grain will tear out the wood. Are my fears valid and what is the preferred method? For flush trimming plugs, a chisel plane or a wide chisel (bevel up) are also good. Just use them like a knife, slicing the plug. Like the others said, sharpness is all here too. Quote
Eric. Posted March 8, 2016 Report Posted March 8, 2016 Yeah direction of cut is critical. You can also chamfer first if you HAVE to plane unsupported fibers, but that still makes me nervous. And as stated, super sharp and super light cut. Low angles excel at cutting end grain (the only thing they excel at) but I level tails and pins with my #4 all the time. Quote
Rex Edgar Posted March 8, 2016 Author Report Posted March 8, 2016 Thanks for all the replies, now on to sharpening the planes I have. Couple of videos on the web, I've been looking at....Thanks again....I hear you SHARP! Quote
Barron Posted March 8, 2016 Report Posted March 8, 2016 One more tip. Wet the end grain with alcohol or mineral spirits, and follow the advice above. 1 Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.