Popular Post nikbrown Posted September 19, 2017 Popular Post Report Posted September 19, 2017 Due to a temporary relocation for my wife's work I've had to leave my large shop behind for a year... Luckily the house we are renting has a small shop and the landlord was nice enough to leave behind a few tools (craftsman bandsaw, table saw, and drill press). I brought a long a few hand tools and a couple festool systainers to get me by for the year.... I figured this was a good time to try my hand a some CNC based woodworking as well... so I picked up a small x-carve (about a 12"x12" cutting area). Shop projects are always the best way to learn new techniques and tools so I decided to make a little Chisel Rack. No thickness plainer so my dimensioning is done via resaw and handplane. Joinery is handled via festool dominos. CNC based woodworking allows you to catch up on some long overdue reading :-D Everything cut and ready for removal and sanding Dry assembly All glued up and seems to work pretty well: Behold the glorious workbench :-P 10 Quote
mat60 Posted September 19, 2017 Report Posted September 19, 2017 Very nice chisel holder. Never going to say rack again. 1 Quote
Mick S Posted September 20, 2017 Report Posted September 20, 2017 Nice job! I like the rabbeted pocket for the chisels. Quote
Mark J Posted September 20, 2017 Report Posted September 20, 2017 Very well done. The band saw made me smile. I'm using the same vintage model. You gotta like the clean lines of the CNC cut, but it is a wide kerf. 1 Quote
Jean [Fr] Posted September 20, 2017 Report Posted September 20, 2017 Nice work ! I particularly like the way the CNC was used, even if you could made your tenons on a single operation Quote
wdwerker Posted September 20, 2017 Report Posted September 20, 2017 Can't tell her that these days ! Quote
Marmotjr Posted September 22, 2017 Report Posted September 22, 2017 I had to laugh at the wood being hand planed and then run through a CNC. Nice work. 1 1 Quote
nikbrown Posted September 22, 2017 Author Report Posted September 22, 2017 On 9/20/2017 at 12:22 PM, Jean [Fr] said: Nice work ! I particularly like the way the CNC was used, even if you could made your tenons on a single operation My cnc only has 12” cutting area and I used almost every bit of that to get the length I needed.... no extra room to cut tenons also... hence the domino. Quote
nikbrown Posted September 22, 2017 Author Report Posted September 22, 2017 18 hours ago, Marmotjr said: I had to laugh at the wood being hand planed and then run through a CNC. Nice work. Yea I don’t have a surfacing bit yet and didn’t want to generat all that extra dust... (still waiting on my dust shoe to arrive) hand plane makes quick work and minimal mess... would have taken me longer to clamp the wood into the CNC than it did for me to flatten the board with the #5 ... but there was all sorts of irony going on in this hybrid project. 1 Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.