Off-Topic
Non-woodworking topics.
1,903 topics in this forum
-
- 0 replies
- 1.8k views
-
- 12 replies
- 2.4k views
-
- 11 replies
- 2.2k views
-
- 0 replies
- 2.2k views
-
- 2 replies
- 2.5k views
-
- 2 replies
- 3.4k views
-
- 12 replies
- 3.5k views
-
- 3 replies
- 2.1k views
-
- 2 replies
- 2.3k views
-
- 4 replies
- 2.1k views
-
- 1 reply
- 1.9k views
-
- 2 replies
- 2.3k views
-
- 11 replies
- 2.5k views
-
- 1 reply
- 2.1k views
-
- 6 replies
- 4.6k views
-
- 0 replies
- 2.2k views
-
- 1 reply
- 2k views
-
- 8 replies
- 3.4k views
-
- 1 reply
- 2.3k views
-
- 0 replies
- 3.3k views
-
- 5 replies
- 2.7k views
-
- 0 replies
- 2.4k views
-
- 0 replies
- 2k views
-
- 7 replies
- 4k views
-
- 0 replies
- 2.2k views
-
Who's Online 3 Members, 0 Anonymous, 164 Guests (See full list)
-
Forum Statistics
31.8k
Total Topics432.3k
Total Posts -
Member Statistics
25,812
Total Members3,644
Most Online
-
Topics
-
-
Posts
-
-
-
Of course the main event for the carving is the top rail. Here it is before and after sanding ... There will still be a little more shaping and sanding after glue-up ... but it's starting to take shape. -
Maybe ... I guess that depends on what you're trying to remove. It should be just surface prep at that point, if the tool is coarse enough to grind divots, that will be detrimental.
-
So the inner door for the chisel's needs to be 1 1/2" wide all in (front to back) for them to fit /look correct. currently it appears I have about 1 9/16" space from the front of the door to the chisel handle which may be closer than I would like. If that's the case I will just install the door so it sits proud a 1/16 or an 1/8" and then bevel the edge back to the outer door. Not sure if that helps but when I get there I think it will make more sense...maybe
-
-
Popular Contributors
