Dhankx Posted September 7, 2017 Report Share Posted September 7, 2017 I just got a respirator and in one of the reviews someone said to store it in a large plastic bag when not in use. This makes sense from one standpoint, but from another standpoint I would think that the moisture from breathing in it would then cause a bacteria problem because it wouldn't properly dry out. Thoughts / suggestions? Quote Link to comment Share on other sites More sharing options...
mat60 Posted September 7, 2017 Report Share Posted September 7, 2017 I wipe the inside of mask out and store in a air tight zip bag so the filters will last allot longer. I guess I never worry a bacteria so much that Im going to replace my filters anymore than I need to. 1 Quote Link to comment Share on other sites More sharing options...
drzaius Posted September 7, 2017 Report Share Posted September 7, 2017 Keep the respirator in a place where it won't get a ton of dust on it & you're good. It's the organic vapor cartridges that can benefit from being stored in a sealed bag. Left open, particularly for long periods of time, they can passively absorb stuff out of the air, theoretically shortening their life. No idea how much shorter, but sometimes I'll go months without using the vapor cartridges so I keep them in a ziplock bag. Quote Link to comment Share on other sites More sharing options...
..Kev Posted September 7, 2017 Report Share Posted September 7, 2017 Not that OSHA really applies to any of our personal shops but, they have very specific guidelines for the storing of respirators. In fact, the refineries that I work in could receive pretty healthy fines if they're found not to be stored properly. Suggest wiping them clean (I use alcohol wipes) when done and storing them in a seal-able bag. I'll also be the first to admit that I'm often guilty of improper storage 2 Quote Link to comment Share on other sites More sharing options...
drzaius Posted September 7, 2017 Report Share Posted September 7, 2017 2 minutes ago, TIODS said: I'll also be the first to admit that I'm often guilty of improper storage Me too. Typically, I just try to remember to put it on the shelf with the open side down. 2 Quote Link to comment Share on other sites More sharing options...
Ronn W Posted September 7, 2017 Report Share Posted September 7, 2017 I hang mine on the door jamb outside of my shop and wipe it down occassionlly. Quote Link to comment Share on other sites More sharing options...
Popular Post RichardA Posted September 7, 2017 Popular Post Report Share Posted September 7, 2017 What have you got against spiders? Jeez! 3 Quote Link to comment Share on other sites More sharing options...
Adam Campbell Posted September 7, 2017 Report Share Posted September 7, 2017 I put mine in a gallon size zip lock bag. I dont think you really need to worry much about bacteria unless you put it in the bag and don't use it again for weeks and weeks. That or you carry some crazy mutating virus. As long as its yours and you are not sharing it, you shouldn't have any problems. Quote Link to comment Share on other sites More sharing options...
Eric. Posted September 7, 2017 Report Share Posted September 7, 2017 I store mine wherever it gets tossed. Every once in a while I'll blast it out with compressed air. I'm on board with safety and everything but if you're that paranoid about breathing a tiny bit of dust...woodworking probably ain't for you. Cuz you're gonna breathe it. 1 Quote Link to comment Share on other sites More sharing options...
rodger. Posted September 7, 2017 Report Share Posted September 7, 2017 I have a hook outside the shop door where I hang my respirator and apron at the end of the day. I keep the pink filters on it, but put the organic vapour cartridges in a sealed ziplock to help them last longer. 2 Quote Link to comment Share on other sites More sharing options...
wtnhighlander Posted September 7, 2017 Report Share Posted September 7, 2017 When I wear a respirator, the combined vapor and sweat accumulate enough that I have to pour it out every half-hour or so. If I don't clean it and keep it sealed, it grows whiskers faster than I do. 2 Quote Link to comment Share on other sites More sharing options...
wdwerker Posted September 7, 2017 Report Share Posted September 7, 2017 I wipe mine out after a spray session and let it dry out overnight then I store it in a ziplock . I don't want to store the filters with moisture in them. Quote Link to comment Share on other sites More sharing options...
Marmotjr Posted September 7, 2017 Report Share Posted September 7, 2017 3 hours ago, Adam Campbell said: I put mine in a gallon size zip lock bag. I dont think you really need to worry much about bacteria unless you put it in the bag and don't use it again for weeks and weeks. That or you carry some crazy mutating virus. As long as its yours and you are not sharing it, you shouldn't have any problems. I stored mine in a bag for years in an industrial environment. I'd wipe it out before and after use, and I'd be good to go. Most of the face masks I've had have come with a plastic storage bag, otherwise, just follow the instructions yours came with. My full face respirator is still stored in a bag, while my half face floats loose in my tool bag. Never had a mold or mildew issue with either. Proper cleaning before and after is the key. Quote Link to comment Share on other sites More sharing options...
Adam Campbell Posted September 8, 2017 Report Share Posted September 8, 2017 4 hours ago, wtnhighlander said: When I wear a respirator, the combined vapor and sweat accumulate enough that I have to pour it out every half-hour or so. If I don't clean it and keep it sealed, it grows whiskers faster than I do. You working in a high altitude sauna? Why are you producing so much moisture? Quote Link to comment Share on other sites More sharing options...
Marmotjr Posted September 8, 2017 Report Share Posted September 8, 2017 4 hours ago, wtnhighlander said: When I wear a respirator, the combined vapor and sweat accumulate enough that I have to pour it out every half-hour or so. If I don't clean it and keep it sealed, it grows whiskers faster than I do. 26 minutes ago, Adam Campbell said: You working in a high altitude sauna? Why are you producing so much moisture? Adam's right.... you shouldn't be producing that much liquid, or at least it shouldn't be trapped in the mask. Granted the majority of moisture released by the body goes through the lungs, but the valves on your mask should easily accommodate this. You might want to try another brand to see if the problem is resolved. I've worn full face masks respirators in 120* heat before, and it takes a couple hours before it starts sloshing around in the mask, but that's in the non ventilated area, so it's only a problem if I turn upside down. A well designed mask should have little to no expiatory effort required, easily venting the moisture. Quote Link to comment Share on other sites More sharing options...
Coop Posted September 8, 2017 Report Share Posted September 8, 2017 Maybe it's time I buy one? Quote Link to comment Share on other sites More sharing options...
JosephThomas Posted September 8, 2017 Report Share Posted September 8, 2017 41 minutes ago, Marmotjr said: Adam's right.... you shouldn't be producing that much liquid, or at least it shouldn't be trapped in the mask. Granted the majority of moisture released by the body goes through the lungs, but the valves on your mask should easily accommodate this. You might want to try another brand to see if the problem is resolved. I've worn full face masks respirators in 120* heat before, and it takes a couple hours before it starts sloshing around in the mask, but that's in the non ventilated area, so it's only a problem if I turn upside down. A well designed mask should have little to no expiatory effort required, easily venting the moisture. I have the same moisture problems described above, and it only takes 10-15 minutes to develop on the hotter days. I've had a couple different kinds of respirators, and I'm in a fairly dry climate (it is pretty hot though). I figure it was just a little different for each person (I sweat quite easily on those hot days too). Quote Link to comment Share on other sites More sharing options...
drzaius Posted September 8, 2017 Report Share Posted September 8, 2017 Mine gets a good heavy coating of condensation after extended use, but not enough to drip out. Quote Link to comment Share on other sites More sharing options...
wtnhighlander Posted September 8, 2017 Report Share Posted September 8, 2017 You working in a high altitude sauna? Why are you producing so much moisture? I'm sure the respiratory moisture is a tiny fraction. I perspire heavily in the non-climate-controlled workshop. And humidity is pretty high here most of the year. I have the same issue with respirators at work. On the rare occasion I am called to diagnose control system failures on the overhead cranes in the furnace area of the plant, I sometimes have to empty my mask before I reach the top of the stairs to the catwalk (75'). Of course, the ambient temp hits 160F at times .... Quote Link to comment Share on other sites More sharing options...
ben_r_ Posted September 8, 2017 Report Share Posted September 8, 2017 At the end of the day I put mine back in the Zip-Loc bag I store it in but leave it open at least overnight to let the moisture evaporate. Then I seal it up the next day if Im not going to be using it. Seems to work fine for me. Quote Link to comment Share on other sites More sharing options...
AJ_Engineer Posted September 8, 2017 Report Share Posted September 8, 2017 Store mine in a cabinet. Let's it dry out and keeps the dust out of the inside. No issues for me. Just using particulate filters not the O-Chem packs though. Once you crack those packs open they have a very definitive shelf life and those are the ones you can extend by storing in air tight containers. Quote Link to comment Share on other sites More sharing options...
Dhankx Posted September 8, 2017 Author Report Share Posted September 8, 2017 12 minutes ago, AJ_Engineer said: Store mine in a cabinet. Let's it dry out and keeps the dust out of the inside. No issues for me. Just using particulate filters not the O-Chem packs though. Once you crack those packs open they have a very definitive shelf life and those are the ones you can extend by storing in air tight containers. Hm. So I am a bit confused . I asked in another thread of suggestions for a respirator and didn't get any specifics. So I got this which says fumes and dust https://smile.amazon.com/gp/aw/d/B00009363G/ref=yo_ii_img?ie=UTF8&psc=1 but some of your comments made me look deeper and now I see there's a difference between vapors and dust filters, so did I get the wrong thing? Quote Link to comment Share on other sites More sharing options...
Adam Campbell Posted September 8, 2017 Report Share Posted September 8, 2017 35 minutes ago, Dhankx said: Hm. So I am a bit confused . I asked in another thread of suggestions for a respirator and didn't get any specifics. So I got this which says fumes and dust https://smile.amazon.com/gp/aw/d/B00009363G/ref=yo_ii_img?ie=UTF8&psc=1 but some of your comments made me look deeper and now I see there's a difference between vapors and dust filters, so did I get the wrong thing? Depends on what you are doing with it, but there are different filters that you attach to the respirator based on what you plan on doing. If you are cutting wood you are not concerned with vapor, if you are spraying finish you want one that will protect you from vapor. Its easier to have 2 respirators one for each task, but you can just as easily switch out the filters as you need it. The vapor ones have a more finite life span. Quote Link to comment Share on other sites More sharing options...
Dhankx Posted September 8, 2017 Author Report Share Posted September 8, 2017 5 minutes ago, Adam Campbell said: Depends on what you are doing with it, but there are different filters that you attach to the respirator based on what you plan on doing. If you are cutting wood you are not concerned with vapor, if you are spraying finish you want one that will protect you from vapor. Its easier to have 2 respirators one for each task, but you can just as easily switch out the filters as you need it. The vapor ones have a more finite life span. Right but looking specifically at what I linked , does it filter dust? Says it does but also lists vapors Quote Link to comment Share on other sites More sharing options...
Adam Campbell Posted September 8, 2017 Report Share Posted September 8, 2017 3 minutes ago, Dhankx said: Right but looking specifically at what I linked , does it filter dust? Says it does but also lists vapors Seems like it protects for everything, except urethane paints. Just dust filter replacements will probably cost less than these filters if you are only using it for wood work. 1 Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.