Popular Post Tom King Posted September 3, 2025 Popular Post Report Posted September 3, 2025 Cabinets are easy, but I wouldn't want to build them by myself. I always built the cabinets for the new houses I built, but I always had a couple of helpers that did all the moving stuff around and helping hold while we assembled them. We didn't have far to move them though. We'd assemble a box in the on site shop in the garage and go put it where it went in the house. Finishing cabinets was a part of finishing everything else in the house. 4 Quote
Popular Post drzaius Posted September 5, 2025 Popular Post Report Posted September 5, 2025 Here's my first tomato harvest that I picked today, except for the dozen or so that have already been eaten. This is just a fraction of what we'll get if the frost holds off. 6 Quote
Popular Post wtnhighlander Posted September 5, 2025 Popular Post Report Posted September 5, 2025 I finally hung the 'experimental' upper cabinets. Made from leftovers and un-painted, they are not pretty, but very practical. Please ignore the clutter... work in progress. These are super light, quite strong, and very simple, very cheap. If anyone is interested, I'll journal the next one, and discuss my reasoning for design, material choice and construction methods. 9 Quote
Beechwood Chip Posted September 5, 2025 Report Posted September 5, 2025 I like them! The garage doors are a nice inexpensive compromise between an open shelf and keeping the dust off. 1 1 Quote
fcschoenthal Posted September 6, 2025 Report Posted September 6, 2025 Do you have any issues raising the door on the top cabinet up against the ceiling? I'm 6' and could probably do it, but reaching over the sanders would make it more difficult. 1 Quote
Popular Post wtnhighlander Posted September 6, 2025 Popular Post Report Posted September 6, 2025 @fcschoenthal, I can do it from the floor, but having a small step to stand on helps. My shop shed ceiling is a shade less than 8', and I have 1" rubber mat on the floor there. The cabinet is also 3/4" below the ceiling. And most of the time, I won't open & store that door, just swing it up and grab what I need. That one is all adhesives. 3 Quote
Coop Posted September 6, 2025 Report Posted September 6, 2025 @drzaius, what brand tomatoes are those? They look fantastic! I planted my 18 plants today. 2 Quote
Mark J Posted September 6, 2025 Report Posted September 6, 2025 14 hours ago, drzaius said: Here's my first tomato harvest They look delicious. 2 Quote
Popular Post Mark J Posted September 6, 2025 Popular Post Report Posted September 6, 2025 14 hours ago, wtnhighlander said: Please ignore the clutter... What clutter? 1 2 Quote
Popular Post Mark J Posted September 6, 2025 Popular Post Report Posted September 6, 2025 @wtnhighlander, that space between the top cabinet and the ceiling is sure to collect dust. You could tuck some backer rod (aka rope caulk) into the gap. 3 Quote
wtnhighlander Posted September 6, 2025 Report Posted September 6, 2025 @Mark J, you are correct. I left the gap because the ceiling isn't perfectly flat, and forced the box off-level. I am debating if I should 'caulk' the gap as you suggested, or relocate my long saw guide storage so it tucks into that space. It is clipped to the ceiling, visible in the second photo. 2 Quote
Von Posted September 6, 2025 Report Posted September 6, 2025 BTW, I would predict that I would tend to always leave the doors open, which would kinda defeat the purpose as I understand it. I would be tempted to paint the front of the doors with blackboard paint or something akin to a whiteboard to make them part of my workflow (by writing myself notes, shopping lists, etc.), so that I would be motivated to close them regularly. 1 1 Quote
Popular Post drzaius Posted September 6, 2025 Popular Post Report Posted September 6, 2025 12 hours ago, Coop said: @drzaius, what brand tomatoes are those? They look fantastic! I planted my 18 plants today. Don't know what brand, but they are heirloom beefsteak. Very meaty and flavorful. I have 8 plants 6 Quote
Popular Post wtnhighlander Posted September 6, 2025 Popular Post Report Posted September 6, 2025 @Von, that is an excellent idea. Another step toward becoming more organized... MDF will remain stable, I hope. This let's me consolidate my ridiculous collection of (mostly) cheap router bits, and eliminate several random containers. Here is a forest of (mostly) useless bits... I mean, how many totally unused ogee bits can a guy own??? Anyway, the board is repurposed from a shelf that was replaced by the cabinets. In now rests perfectly on the remaining shelf, well protected by the cabinet above. 6 Quote
Popular Post Von Posted September 7, 2025 Popular Post Report Posted September 7, 2025 Helped a friend fix a broken chair leg. I've done this a few times now and still find it very challenging to find a way to clamp given what is inevitably two non-parallel legs at an acute angle. Even with shims and blue tape, the clamp wants to slip on the finished surfaces. We got the leg in place and then drove a screw from the underside to hold it in place because I didn't trust the clamp. I didn't get a photo of the main clamp-up, the photo is post glue-up and screwing with a small clamp just to keep it from twisting around the screw as it dried. 6 Quote
Popular Post Tpt life Posted September 7, 2025 Popular Post Report Posted September 7, 2025 One of the best tips I have see for this uses pins and CA glue. The presenter used clipped 18g nails for registration, applied CA to the very center, and some kind of white glue to all the rest. It provided less need for clamping and you could focus on alignment 5 Quote
Popular Post wtnhighlander Posted September 7, 2025 Popular Post Report Posted September 7, 2025 Checked one off the honey-do list today. When we built this house, surrounded by row crops, we chose a touch of nostalgia decor, and put up an antique dinner bell. This treated post has been in place, directly in the clay, for 33 years: As solid below the ground as above. However, it did develop a bow, and a bit of lean. I got it back to plumb (-ish), and made shims to pad out the bow, so it is again straight (-ish). Then I whapped it with WRC, like the house: Plan is to stain it the same as the house. But my next shop project is ready to start... I have to "hew" this cypress half-log and its mate down to square-ish beams, from which to make an outdoor bench (seat & back). Remaining log sections will for the legs, back supports, etc... 7 Quote
ShannaHn Posted September 8, 2025 Report Posted September 8, 2025 Great idea! Threads like this really help build a lively community where people share not only their projects but also moments from daily life. It brings members closer and makes communication warmer and more sincere. 1 Quote
Mark J Posted September 8, 2025 Report Posted September 8, 2025 17 hours ago, wtnhighlander said: have to "hew" this cypress half-log and its mate down to square-ish beams, from which to make an outdoor bench (seat & back). Remaining log sections will for the legs, back supports, etc... Speaking of rustic . This sounds like another journal (please). 2 Quote
Popular Post legenddc Posted September 8, 2025 Popular Post Report Posted September 8, 2025 Fun weekend here. Got some time in the shop, had my in-laws come over to watch the kids while we went to a friend's surprise 40th party, kids started volleyball/basketball on Sunday and my sister had her baby last night. 3 Quote
Coop Posted September 9, 2025 Report Posted September 9, 2025 Ross, that bell is cool. Keep us us to date on the bench. 1 Quote
Popular Post gee-dub Posted September 15, 2025 Popular Post Report Posted September 15, 2025 On 9/5/2025 at 3:48 PM, wtnhighlander said: Made from leftovers and un-painted, they are not pretty, but very practical. I have several shop fixtures that are made out of leftovers. They have served me well for many years. I do get a little jealous of the beautiful tool cabinets that some folks have. I think I will still have furniture pieces on my to-do list once I get too old for this sport. I guess the functional fixtures will have to suffice unless I live to be 100 and can replace them 3 Quote
legenddc Posted September 15, 2025 Report Posted September 15, 2025 Things have been busy lately at work and home. Got to see my nephew twice last week, once just briefly so our kids could meet their cousin. Took the kids to their first real concert on Saturday night as an early birthday present for my son. They had a fun time. Tonight we're headed to a Nationals baseball game. Thankfully this weekend we don't have anything planned. 2 Quote
Popular Post Von Posted September 15, 2025 Popular Post Report Posted September 15, 2025 My big accomplishment for the day? 7 Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.