Turner's Corner
603 topics in this forum
-
- 1 reply
- 1.4k views
-
- 9 replies
- 10k views
-
- 0 replies
- 1.5k views
-
- 15 replies
- 2.8k views
-
- 44 replies
- 6.5k views
-
- 28 replies
- 13k views
-
- 13 replies
- 6.2k views
-
- 2 replies
- 1.9k views
-
- 8 replies
- 4.8k views
-
- 4 replies
- 2k views
-
- 13 replies
- 10.7k views
-
- 23 replies
- 5.5k views
-
- 13 replies
- 15.2k views
-
- 11 replies
- 2.9k views
-
- 7 replies
- 4.2k views
-
- 0 replies
- 1.8k views
-
- 8 replies
- 4.3k views
-
- 6 replies
- 2.8k views
-
- 13 replies
- 4.3k views
-
- 16 replies
- 3.2k views
-
- 23 replies
- 11.6k views
-
- 13 replies
- 4.1k views
-
- 4 replies
- 4.1k views
-
- 21 replies
- 5.5k views
-
- 19 replies
- 3k views
-
Who's Online 4 Members, 0 Anonymous, 51 Guests (See full list)
-
Forum Statistics
31.2k
Total Topics422.2k
Total Posts -
Member Statistics
23,783
Total Members3,644
Most Online
-
Topics
-
-
Posts
-
Thank you - I will definetly need that too -
By wtnhighlander · Posted
I don't kniw what GF product you are using, but every can of their 'Milk paint' I ever opened was darn near DQ 'Blizzard' consistency. I can't imagine spraying it. However, a foam brush gives me a very smooth finish, as the stuff self-levels quite well. But....I always seem to need 3 coats to get non-translucent coverage. -
-
By wtnhighlander · Posted
Cabinet doors really benefit from sanding after assembly, a drum sander (or wide belt sander for higher volume) might be worth adding to the list. If you are doing thus commercially, go wide on the jointer. Hobbyists can afford the extra time to use planer jugs & such, to get by with a narrow jointer, or none at all. -
By wtnhighlander · Posted
Mark the center point for the domino on the ends of the box, the tap a small finish nail int the mark. Snip it off about 1/8" above the surface, and it becomes the 'dowel center' to mark the overhanging top & bottom pieces. Drill and appropriate pilot hole to make the cut off nail easy to extract.
-
-
Popular Contributors
