Finishing
2614 topics in this forum
-
- 2 replies
- 129 views
-
- 5 replies
- 189 views
-
- 4 replies
- 215 views
-
- 7 replies
- 271 views
-
- 7 replies
- 271 views
-
- 14 replies
- 406 views
-
- 8 replies
- 276 views
-
- 16 replies
- 685 views
-
- 7 replies
- 339 views
-
- 6 replies
- 806 views
-
- 15 replies
- 335 views
-
- 16 replies
- 542 views
-
- 7 replies
- 243 views
-
- 8 replies
- 263 views
-
- 10 replies
- 312 views
-
- 30 replies
- 1342 views
-
- 8 replies
- 365 views
-
- 2 replies
- 188 views
-
- 18 replies
- 1185 views
-
- 10 replies
- 1881 views
-
- 8 replies
- 319 views
-
- 3 replies
- 321 views
-
- 4 replies
- 340 views
-
- 10 replies
- 505 views
-
- 15 replies
- 1468 views
-
Who's Online 4 Members, 0 Anonymous, 280 Guests (See full list)
-
Forum Statistics
28516
Total Topics384213
Total Posts -
Member Statistics
-
Topics
-
-
Posts
-
I went to use one of my bessey clamps a couple days ago, and suddenly my shelf was not sitting square and tight in my case. Took the shelf out, fiddled a bit, and then the gap was on the opposite corner! (I had ended up reversing the orientation of the clamp) Mine was out of square by about the same amount shown in OP’s pic. Grabbed another off my wall and it was correct- just slightly out of square in the opposite direction. I was in HD yesterday and took one of their nicer speed squares over to the clamps and one of the four 24” clamps they had on the shelf was like this. I’ll be sure to check them before I buy them in the future. -
Very nice, like the clean lines and the attention to detail with the continuous grain. Did you use anything to reinforce the miter joints? I'm assuming dominos but wasn't sure. I agree with you on the MCM stuff, kind of grows on you. -
By duckkisser · Posted
dude I think I would have bought a new house before I moved all that in basement. or built a ramp -
Thank you everyone. I didn’t like MCM until I started building it for my clients and now I actually like it. I think I saw too much “DIY” that was built like crap and with bad design. When done right, not that I am doing it right, I think it looks good and is actually a challenge to build. -
-
-
Popular Contributors
-
1
-
2
-
3
-
4
-
5
-
