Recommended Posts

Posted

Some recent happenings in my area have me thinking about installing a few security cameras around my house.

I know cameras have become extremely reasonably priced so now is probably the time.  I'd be in on a wireless wifi/android based system. 

I'll do one camera above the garage that should give good view of the front of the house, and two cameras in the back of the house, covering the deck area and the walkout basement. 

The power source for the garage is easy, but the back of the house not so much.  I don't know how to run power back there.  

Then there is mounting... I'm not sure of the cleanest way to do the installation though.  Into the soffit?  Into the siding?  Pictures of the house show the type of siding/soffit, etc.  

Anyone have experience? 

20180128_163343.jpg

20180128_163330.jpg

Posted
8 hours ago, Chet said:

Instead of going to all this trouble can't you just call the police department. :lol::lol::lol:

Therein lies the problem...it would seem we've got a group targeting us, again.   

We'll get it sorted out, this has happened before...but every time it does it makes us think about upping our security. 

  • Like 2
  • Sad 2
Posted

Power for the cameras are 12vdc.  Power all of the cameras from the same source,  since you have power to the garage camera run your wires underneath the eve between the garage and house to your back deck.  The last camera install I did allowed for 500' wire run. Should be a relatively easy install.  I had to do several installs over the course of my career, the department fround on my choice of lenses, they said 5.56 or .223 was inapropriate, so I had to go to Costco......

Posted

I have installed wired cameras externally and limit wireless cameras to internal usage only. The wired cameras called power over ethernet cameras are far more reliable than wireless cameras and a single cable carries both power and data. Most also have infra red illumination built in. I figure if you are going to the trouble of trying to run 12v DC to each camera and then struggle getting a wireless camera to connect to the router you may as well run an ethernet cable carrying the power too and forget about wireless!

Essentially you run a CAT5e or CAT6 cable to each camera. Then dependent upon the camera you have to crimp an Ethernet connector onto the cable after passing it through the weather proof mechanical connector.

At the other end of the cable have them come to a centralized point inside the house and again crimp ethernet connectors onto each cable. Then you will need an ethernet switch that will supply power over ethernet. There are many of these available and a small 8 port switch will suffice - have a look on Amazon. Then run an ethernet cable from that switch to your internet router, install the relevant app (the camera manufacturers normally have one) onto your smartphone and you can receive a live feed wherever you are.

If you are unsure how to do the cabling then a quick call to an installer will get them to help you. Basically those cheap wireless cameras are not as good as they could be and a wired installation is far better, very reliable and high definition for just a few bucks more.

 

If you want to go deeper into having a home server that collects the images triggered by movement detection then there are a few free programs available on the internet. iSpy https://www.ispyconnect.com/ is a good one but the best one I have found is Milestone Xprotect Essential https://www.milestonesys.com/xprotectessential . The latter gives you up to 8 cameras for free. The former is open source software with a paid for option. However I find iSpy is very cpu intensive.

ISpy runs on a windows platform (Windows 7 and newer) and I believe the Xprotect is also Windows only (Windows 7 and newer). There are plenty of old refurbished PCs available on the internet relatively cheaply that can be pressed into service as a camera server. All you need is a big disk to store the images/videos and again a 2TB drive is insanely cheap these days. 

 

  • Like 1
Posted

Looks like vinyl siding and either vinyl or aluminum soffit. Those are plug and play items that, unless super old and brittle, come apart and go back together easily. Should be no big deal to get wires to attic space. 

Posted

I think it's unfortunate that this is the type of world that we live.

A god friend of mine camera'd his house using those power over Ethernet cameras and they are slick. I'd also stay away from wireless for security you want the reliability. I can't remember what he used for software but he had it routed though the coax in his hose where he could turn on the tv and see who was pulling into his driveway.

Posted
2 minutes ago, Tom King said:

How much do the services like RIng, and Simplisafe cost?

I'm not familiar with Ring, but Simplisafe is extremely reasonable.  SS doesn't seem to have any external options though.  I'm not so concerned with anyone getting inside the house. 

Reading through and researching all the other info guys. 

Posted

I installed floodlights on all 4 sides of my house. On the gable ends I ran the wire across the attic and mounted the fixture under the eaves so it got a little protection. Luckily my 24' ladder reached that point. Switching to LED bulbs has greatly reduced how often I have to drag the ladder out. The 2 lower eaves sides I fished the wire from the outside into the attic to avoid having to crawl into such a tight spot.

Posted

The power over ethernet option is viable, my internet router is in my unfinished basement so of I can run wires around the house, getting them to the router shouldn't be too difficult. 

Posted

Ring is the doorbell video camera that you can see on your phone. The price of the actual camera/doorbell is $100-200 depending on the sale. I think they now have some wireless cameras.

Every time I think about adding cameras I get concerned over the monthly fee for motion activated video recording and how long that company will be in business. Wired installation and an old PC to record it all would eliminate that, but I don't know if I feel like messing with it.

Good luck to whatever you choose. Let us know how it works out.

Posted

I've been looking into adding a couple cameras to the house myself.   PoE is the route to go, as you then just need to run the CAT5.   I haven't quite worked out where or what I'm doing with this.   We haven't really had any problems.   One of our neighbors down the road had a breakin about 2 years ago, but they figure it was a subcontractor who came into the house to do work as they knew to go to the basement and look in the closet to find the gun safe.

I bought a QNAP TS-451+ SOHO NAS last year to store photos and other home stuff on, and it has built in software to monitor video cameras.   I believe Synology has something similar.

 

 

Posted
3 minutes ago, legenddc said:

Every time I think about adding cameras I get concerned over the monthly fee for motion activated video recording and how long that company will be in business. Wired installation and an old PC to record it all would eliminate that, but I don't know if I feel like messing with it.

This is a good point.

There's been many a company that has simply vanished.   Or the product they sold no longer works because they shut the servers off.

I think you'd want something that was independent and once setup didn't need to be touched.

And there are security companies out there who you can hire to set it all up for you and you don't have to mess with anything.

Posted

I've thought about using the motion detection part of the motion light, hook it up to a small speaker that plays back the sound of a pump shotgun jacking a shell into the chamber. Everyone knows that sound and would head the opposite direction.

Posted

Any thoughts on where the cameras should be mounted?  Seems like most time security footage is shown on the news all you can see is the tops of people's heads.  

Mounting the camera high up may keep it out of mischief, but camoflaged or hidden and lower down might protect the camera and give a better view?

  • Like 1
Posted

I agree that mounting up high doesn't always work well if someone has a hat on or similar.  What I would do is build a cheap looking birdhouse and mount on the tree, with a game camera inside.

Posted
5 minutes ago, Bankstick said:

Bryan, what if a bird decides to build a nest in the birdhouse?  But a good idea.

If it was facing the front door, I would leave the front off, the sides would be more so if you where walking past you wouldn't see the camera.  Also if you made it with a front, but built so the fit was tight a bird could have a hard time building a nest.

Posted

If you are tech savvy at all, check into ZoneMinder. It is an open-source NVR / Security software that runs on Linux. Free to download and operate, with paid support available if you don't care for DIY. Records locally, and can be set up for remote viewing. I used it at work for about 4 years before they ponied up for a commercial system.

The commercial security camera system has the advantage of smooth integration between all components, but it cost tens of k$ and doesn't do anything that ZoneMinder couldn't.

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Who's Online   0 Members, 0 Anonymous, 37 Guests (See full list)

    • There are no registered users currently online
  • Forum Statistics

    32k
    Total Topics
    437.5k
    Total Posts
  • Member Statistics

    26,007
    Total Members
    3,644
    Most Online
    FurniCore
    Newest Member
    FurniCore
    Joined