Power Tools
4,152 topics in this forum
-
- 19 replies
- 676 views
-
- 9 replies
- 599 views
-
- 6 replies
- 777 views
-
- 7 replies
- 320 views
-
- 1 reply
- 359 views
-
- 11 replies
- 2.4k views
-
- 5 replies
- 596 views
-
- 21 replies
- 546 views
-
- 0 replies
- 276 views
-
- 2 replies
- 754 views
-
- 18 replies
- 888 views
-
- 38 replies
- 21.5k views
-
- 1 reply
- 411 views
-
- 28 replies
- 1.1k views
-
- 5 replies
- 596 views
-
- 6 replies
- 592 views
-
- 8 replies
- 746 views
-
- 59 replies
- 2.9k views
-
- 4 replies
- 618 views
-
- 23 replies
- 4.3k views
-
- 0 replies
- 518 views
-
- 23 replies
- 41.7k views
-
- 11 replies
- 647 views
-
- 13 replies
- 640 views
-
- 8 replies
- 648 views
-
Who's Online 3 Members, 0 Anonymous, 48 Guests (See full list)
-
Forum Statistics
31.2k
Total Topics422.5k
Total Posts -
Member Statistics
23,790
Total Members3,644
Most Online
-
Topics
-
-
Posts
-
Just to poke at the assumption - you got it out of square putting on the face frame, what makes you so sure you can't rack it back? -
First time i have purchased lumber online. I have been tempted many times but did not want to pay shipping. This time i couldn't travel to my normal (and good) sources. Ocooch was one of the few places that listed Padauk in the size i needed. i ordered two pieces. Delivery was reasonably quick, they were well packaged and the pieces were first rate and dimensioned as they had listed. Should the need arise i would definitely order from them again. Very pleased -
By wtnhighlander · Posted
Well, I knew the glue-up didn't go smoothly, but I wasn't prepared for this. Somehow, the already-glued carcase was pulled out of square during my struggle to get the face frame pieces into place. I only noticed while I was measuring for the inset door frames. There is a strong 3/8" difference in the diagonals now, and no way is it going to rack back into shape. I'm considering my options for going forward. 1. Build the doors to fit the rhomboid openings. The scale of the case makes it all but impossible to see the corners aren't 90*. 2. Trim the face frame to produce a square opening for the doors. 3. Split the difference to avoid the frame pieces being too crooked at any one spot. 4. BBQ. Any suggestions from the collective? -
The PWs are great, and having several layers is super handy. -
Like the temporary puzzle table I made a while back. It’s wobbly but still being used frequently. By replace I meant more of that physical location. I’ll shuffle this around and use it until it falls apart. Might put it in the greenhouse at some point.
-
-
Popular Contributors
-
1
-
2
-
3
-
4
-
5
-
