Finishing

2,868 topics in this forum

1. Another Outdoor Finish Question

   By CubsFan, August 16, 2010
   • 8 replies
   • 4.6k views
   • 
   • PaulMarcel
   • January 21, 2011

3. Low cost hassle free set and forget paint, stain, finish mixer

   By toneslinger, September 8, 2010
   • 3 replies
   • 1.5k views
   • 
   • kesac
   • January 20, 2011

4. Rustic finish for alder

   By TBaiga, January 19, 2011
   • 3 replies
   • 2.9k views
   • 
   • TBaiga
   • January 19, 2011

5. Oak end-grain cutting board finish

   By spxf1113, January 18, 2011
   • 7 replies
   • 5.5k views
   • 
   • spxf1113
   • January 19, 2011

6. Spraying finish indoors w/o a special setup?

   By newbiewoodworker, January 15, 2011
   • 13 replies
   • 4.4k views
   • 
   • Jim_
   • January 18, 2011

7. Lesson Learned ... until I do this again

   By Bobby Slack, January 17, 2011
   • 1 reply
   • 1.2k views
   • 
   • AceHoleInOne
   • January 18, 2011

8. what finish to use on ash

   By gary-g-k, January 17, 2011
   • 3 replies
   • 2.1k views
   • 
   • woodcanuck
   • January 17, 2011

9. Iron marks in table. Steam? Lacquer blush?

   By Sandersonbuilt, January 15, 2011
   • 5 replies
   • 4.1k views
   • 
   • Pete Bennett
   • January 16, 2011

10. Windsor chair: antiquing milk paint

    By builderbob, January 14, 2011
    • 1 reply
    • 2.5k views
    • 
    • HoboMonk
    • January 15, 2011

11. inside of a cabinet

    By Jim_, January 11, 2011
    • 8 replies
    • 2.7k views
    • 
    • Beechwood Chip
    • January 14, 2011

12. Changeover

    By JCDVP, January 14, 2011
    • 0 replies
    • 1.6k views
    • 
    • JCDVP
    • January 14, 2011

13. Blue dye

    By CaptFerd, January 6, 2011
    • 10 replies
    • 7.6k views
    • 
    • CaptFerd
    • January 10, 2011

14. Buffing out water based lacquer topcoat

    By drobathan, January 8, 2011
    • 3 replies
    • 7k views
    • 
    • AceHoleInOne
    • January 10, 2011

15. General Finishes High Performance

    By Renzo, January 8, 2011
    • 9 replies
    • 3.4k views
    • 
    • Renzo
    • January 9, 2011

16. Undermount Sink in a butcherblock countertop

    By jbstudio, January 2, 2011
    • 5 replies
    • 6.5k views
    • 
    • iSawitFirst
    • January 7, 2011

17. Which finish do I use on a project with mulitple species

    By Green Head, December 22, 2010
    • 4 replies
    • 1.4k views
    • 
    • iSawitFirst
    • January 7, 2011

18. Finish for maple mantel

    By Irvingj76, January 5, 2011
    • 1 reply
    • 2k views
    • 
    • AceHoleInOne
    • January 5, 2011

19. Finish for built-ins

    By TBaiga, January 2, 2011
    • 4 replies
    • 1.9k views
    • 
    • TBaiga
    • January 3, 2011

20. Raise the grain on oil based finishes?

    By Pbmaster11, December 31, 2010
    • 2 replies
    • 7.7k views
    • 
    • AceHoleInOne
    • January 1, 2011

21. Teak - stripping down and refinishing

    By woodcanuck, December 8, 2010
    • 5 replies
    • 13k views
    • 
    • Don Z.
    • December 30, 2010

22. Finish for shop cabinets

    By jbeilmann, December 29, 2010
    • 9 replies
    • 5k views
    • 
    • Mister Pants
    • December 30, 2010

23. Danish oil / Shellac

    By rick kinder, December 20, 2010
    • 5 replies
    • 13.4k views
    • 
    • mgradwohl
    • December 29, 2010

24. Sanding Sanding Sanding

    By Bobby Slack, December 11, 2010
    • 9 replies
    • 2k views
    • 
    • Lawrence Brown
    • December 29, 2010

25. That black finish on "modern" furniture?

    By Lawrence Brown, December 25, 2010
    • 10 replies
    • 7.4k views
    • 
    • Bombarde16
    • December 27, 2010

26. Curly Maple and Walnut Finishing

    By gsxturbo11, December 16, 2010
    • 9 replies
    • 2.7k views
    • 
    • Lawrence Brown
    • December 25, 2010