Got the upper door veneers done tonight and cut the strips
Got everything ready to go and realized I didn't have a enough Gorilla glue nor the plastic I need to keep from mucking up my vacuum bag with glue squeeze out. so that will have to wait until tomorrow
Got a new mallet and the switch went out on my Shop Fox spindle sander so I got it and a neoprene pad I saw in a semi recent Fine Woodworking. The ones I have slide on my laminate top where I sand, this one actually doesn't seem to so that's good. I wanted it for a while but wasn't willing to pay $11 shipping on a $25 mat. Since I had to have the $6 switch I paid the $11 shipping and added the mat
Got another bank of lights converted to LED's
Just have these two at the front of the shop and I need to decide if I'm going to do the two fixtures in the spray room now or wait until there's an issue. 4' bulbs should be here tomorrow.
I've been using a hill billy saw guide for at least 40 yrs an old timer ( look who's talking) was using one on a job sight. And I was hooked, I use mine in the shop, and on a job sight. I'm sure I wood fall in love with a track saw but I don't need one.