Started swapping out my florescent lights for LED's since I have started having issues with ballast failures. After 22 years I guess I can't complain to much, especially considering I've never changed a bulb. Same 6000k as the fluorescents but definitely brighter. At first I thought they might be to bright but I found a tip online to turn the tubes a bit and that worked.
You can see high on the wall how much more lit up it is compared to the old ones on the right. I think the ballast on the one over the entry door is going as it started flickering yesterday like the one that went out on me.
I have found a recycling center for the bulbs anyone know if the ballasts can go in the trash? What's in them that makes them so heavy?
Not much work on the cabinet today as I started changing my lights, the dead spot in the middle of the shop was really getting to me, but I did run the stock for the lumber core doors through the J/P I'll start gluing them up later this week.
This little fellow arrived today from Heartwood Tools.
First impressions are very good. The finish is silky smooth and the little "batwing" cut outs in the fence give your fingers a place to go.
Brass hardware and a rounded knife so it'll cut in both directions. Kitty approved.
Another nice thing was a handwritten thank you card from Heartwood Tools.
Looking forward to trying it out.
Thanks @pkinnebfor turning me on to HT!