1913 topics in this forum

    • 15 replies
    • 773 views
    • 8 replies
    • 905 views
    • 14 replies
    • 1017 views
    • 18 replies
    • 1493 views
    • 1 reply
    • 574 views
    • 0 replies
    • 428 views
    • 6 replies
    • 908 views
    • 2 replies
    • 559 views
    • 5 replies
    • 479 views
    • 2 replies
    • 596 views
    • 2 replies
    • 755 views
    • 5 replies
    • 836 views
    • 35 replies
    • 4185 views
  1. Rippin'

    • 6 replies
    • 827 views
  2. Welcome to my Joint

    • 1 reply
    • 586 views
  3. new to sharpening

    • 4 replies
    • 712 views
  4. Record 52 1/2 Vise

    • 2 replies
    • 722 views
    • 8 replies
    • 761 views
    • 9 replies
    • 2358 views
    • 5 replies
    • 1615 views
  5. Groovin' Baby!

    • 3 replies
    • 684 views
    • 6 replies
    • 595 views
    • 8 replies
    • 812 views
  6. Wonky Plane Blade

    • 10 replies
    • 743 views
    • 21 replies
    • 1094 views




  • Popular Now

  • Topics

  • Posts

    • Initial review of my just-purchased 1617: I like it. The plunge is smooth. Fixed base can be mounted in a table, and has adjustability from above the table. Rocker switch is not as convenient as a trigger, but the variable speed controller ramps it up smoothly. The flip-down chip shield is handy. Cons: It has (of course) a different base mount hole radius than any of the 5 other routers I own, so none of my other base-mount accessories fit. Neither baseplate in the kit accepts a guide bushing out of the box. Bosch offers a boat load of accessories, none of which (of course) are included.  Overall, it seems to be a nice machine. If you only had one router, this one is flexible enough to cover most needs.
    • You know your sharpening skills are improving when your block plane shave away half the thickness of your fingernail, and you don't even notice. That was planing into the nail.
    • "I've been veneering many of my projects for an number of years now and I've noticed that I frequently see glue spots (refer to photo) on the veneer once I remove them from the vacuum bag. The glue seems to be weeping through the veneer..? My procedure when veneering is to apply cold press glue to the substrate, attach the veneer, cover it with a piece of door screen and place it into the vacuum bag. I've noticed this problem occurring on open grain species, especially Mahogany and Walnut. Does any one else have this problem; any suggestions..?
    • I believe the thickness of the application is also a factor.
    • I didn't explain myself very well. I didn't mean to disparage the crutch. Crutches are good & I've used them myself. My point was that having difficulty with accuracy is not typically going to be solved by getting a micro adjust. That just makes the process easier & quicker. By all means, get whatever will make your woodworking more enjoyable. I was just suggesting that it would be a good idea to address your issue of not being accurate because that can only be helpful whether you have the micro-adjust or not
  • Popular Contributors