Digital Design
A place to discuss all forms of digital design.
165 topics in this forum
-
- 13 replies
- 9.9k views
-
- 35 replies
- 10.5k views
-
- 16 replies
- 8.8k views
-
- 10 replies
- 6.6k views
-
- 5 replies
- 3.1k views
-
- 6 replies
- 4.3k views
-
- 38 replies
- 14.3k views
-
- 1 reply
- 2.8k views
-
- 11 replies
- 4k views
-
- 11 replies
- 5k views
-
- 2 replies
- 2.8k views
-
- 16 replies
- 5.5k views
-
- 40 replies
- 11.1k views
-
- 9 replies
- 3.7k views
-
- 6 replies
- 2.9k views
-
- 9 replies
- 3.6k views
-
- 10 replies
- 7.4k views
-
- 15 replies
- 8.1k views
-
- 2 replies
- 3.5k views
-
- 26 replies
- 5.3k views
-
- 0 replies
- 3k views
-
- 4 replies
- 3.6k views
-
- 2 replies
- 2k views
-
- 5 replies
- 2.5k views
-
- 12 replies
- 3.6k views
-
Who's Online 0 Members, 0 Anonymous, 108 Guests (See full list)
- There are no registered users currently online
-
Forum Statistics
31.8k
Total Topics433.1k
Total Posts -
Member Statistics
25,831
Total Members3,644
Most Online
-
Topics
-
-
Posts
-
What did the moisture on the surface of the rough lumber get down to? Did you check the moisture after you milled the lumber, and if so, what did it read? -
You’re prob right as I find from the past that most rot is at ground level. -
By Beechwood Chip · Posted
Disclaimer: I have no experience, I'm just blowing smoke. I'd coat the bottom, since I'd be more concerned about ground water wicking up into the wood, than about water working it's way down from the sides or top. I figure the upper parts are breathing moisture in and out, but the bottom is basically sitting in a puddle. -
-
Dang, has it been 18 months already? Sometimes you work the wood and others, the wood works you.
-
-
Popular Contributors
